Size of a 20MW Synchronous Motor for Ship Propulsion

AI Thread Summary
A 20MW synchronous motor for ship propulsion is not easily found in specific size references, but comparisons can be made with existing vessels. The P&O ship "Aurora" utilizes 20MW motors, though exact dimensions are not readily available. Nuclear submarines, such as the SSN-688, use a hot water turbine system instead of an electric motor, with a power output of approximately 26MW. The discussion also suggests that older diesel submarines might use motors in a similar size range. Further research and datasheets may provide more insights into the size of such motors.
gcomyn
Messages
3
Reaction score
0
Does anyone know how big a 20MW synchronous motor would be to drive a ship's propellor?
 
Engineering news on Phys.org
How big are nuclear submarine motors? Off to google I go...
 
The P&O ship "Aurora" uses 20 MW motors but I can't find how big they are anywhere...
 
berkeman said:
How big are nuclear submarine motors? Off to google I go...
I googled nuclear submarine motor size, and got lots of hits. Here's one of the first ones -- pretty interesting info:

http://www.fas.org/man/dod-101/sys/ship/ssn-688.htm

Power Plant One S6G reactor
one shaft at 35,000 shp
Improved Performance Machinery Program Phase I [on 688 Improved]

Length 360 feet (109.73 meters)

Beam 33 feet (10 meters)

Oops, I just reallized that they drive the propeller shaft directly with the hot water turbine, not via an electric motor. My bad. But 35,000 shp is about 26MW, which is in your size range. Hmmm, what else uses a motor that size... Maybe an old diesel submarine. I'd head off to google again, but I need to get back to work...here comes the boss! :biggrin:
 
"Aurora" datasheet here
http://www.solentwaters.co.uk/Article%20Chest/Cruise%20Ship%20Diesel%20Electric%20Propulsion.pdf
 
Last edited by a moderator:
gcomyn said:
"Aurora" datasheet here
http://www.solentwaters.co.uk/Article%20Chest/Cruise%20Ship%20Diesel%20Electric%20Propulsion.pdf
Well if that drawing is to scale, then that gives you the motor size, right? Is that what you're looking for?
 
Last edited by a moderator:
Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
Thread 'Electromagnet magnetic field issue'
Hi Guys We are a bunch a mechanical engineers trying to build a simple electromagnet. Our design is based on a very similar magnet. However, our version is about 10 times less magnetic and we are wondering why. Our coil has exactly same length, same number of layers and turns. What is possibly wrong? PIN and bracket are made of iron and are in electrical contact, exactly like the reference design. Any help will be appreciated. Thanks. edit: even same wire diameter and coil was wounded by a...
Back
Top