Small Angle Approximation in Single Slit Interference

AI Thread Summary
The discussion revolves around the use of the small angle approximation in a double slit interference scenario. A monochromatic light source creates an interference pattern, with the second bright spot located 8.73 mm above the central maximum on a screen 2.00 meters away. The small angle approximation can be applied since the calculated angle θ is approximately 0.00436 radians or 0.25 degrees, which is considered very small. The relationship between the distance to the screen (D) and the distance between slits (d) is crucial, with the condition D >> d being necessary for accurate approximations. Ultimately, the small angle approximation is validated for this specific setup.
lulzury
Messages
8
Reaction score
0

Homework Statement


A monochromatic light source is used with a double slit to create an interference pattern on a screen that is 2.00 meters away. If the 2nd bright spot is observed 8.73 mm above the central maximum, can the small angle approximation be used? Show and/or explain your reasoning

Homework Equations


## d\sinθ=mλ ##

The Attempt at a Solution


I might be over-thinking this. I know you can have a small angle approximation if D >> d, but in this case I don't know d yet, so I first wanted to relate d to y without first assuming a small angle approximation (sinθ ≈ tanθ ≈ θ), but I get stuck:

p6hLM2y.jpg


I get the following relation:
## D=\frac{d}{2\tan(γ)} ##
## D= (y+\frac{d}{2}) * \frac{1}{ \tan(θ)} ##

## \frac{d}{2}\cot(γ) = y\cot(θ) + \frac{d}{2}\cot(θ) ##

I'm not sure how to solve for d here so that I can show that D >> d.

Thanks in advance!
 
Physics news on Phys.org
D>>d/2 is necessary for other approximations (all your formulas wouldn't work without that condition).

The small angle approximation that is relevant here is a small θ. You can calculate θ with D and y alone in a single step.
 
  • Like
Likes lulzury
mfb, that makes sense thank you!

So in this case tan(θ) = y/D

## θ = \arctan(\frac{y}{D}) ##
## θ = \arctan(\frac{8.73*10e-3}{2}) ##

θ = 0.00436 rad ~ 0.25 degrees
That is a very small angle, so I can use a small angle approximation here!
 
Right.
 
  • Like
Likes lulzury
TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...
Thread 'Variable mass system : water sprayed into a moving container'
Starting with the mass considerations #m(t)# is mass of water #M_{c}# mass of container and #M(t)# mass of total system $$M(t) = M_{C} + m(t)$$ $$\Rightarrow \frac{dM(t)}{dt} = \frac{dm(t)}{dt}$$ $$P_i = Mv + u \, dm$$ $$P_f = (M + dm)(v + dv)$$ $$\Delta P = M \, dv + (v - u) \, dm$$ $$F = \frac{dP}{dt} = M \frac{dv}{dt} + (v - u) \frac{dm}{dt}$$ $$F = u \frac{dm}{dt} = \rho A u^2$$ from conservation of momentum , the cannon recoils with the same force which it applies. $$\quad \frac{dm}{dt}...
Back
Top