Tension. Application of Newton's Laws.

AI Thread Summary
The discussion focuses on calculating the tension in cables A, B, and C supporting two weights. For cable A, the tension is determined to be 150 N, as it only supports the large box. The tensions in cables B and C are derived from the combined weights of both boxes, resulting in a total tension of 256 N, which is then divided by two to yield 128 N for each cable. Participants emphasize the importance of considering equilibrium and the geometry of the setup when solving the problem. Overall, the calculations confirm the relationships between the weights and tensions in the system.
valeriex0x
Messages
43
Reaction score
0

Homework Statement



Two weights are hanging by the following cables, A, B, C.
1. Find the tension in Cable A.
2. Find the tension in Cables B and C.

-----ceiling----------
\ 60) (60 /
\ /
\ /
B \ / C
\ /
\ /
[_] small box:72 N
|
A |
~~~
| | Big Box: 150 N
~~~

Homework Equations



Free body diagram of big box, maybe some trig for finding cables b or c


The Attempt at a Solution



1.
I know that the big box has a Force:weight pointing down of 150 N, and normally, if it was resting on a flat surface it would have normal force pointing up 150N. But because it is suspended by cable A from small box 72N, I'm not sure how to approach finding the tension in cable A. Would it be okay to think the tension in cable A is 150 N + 72 N?

2.
I am thinking I could draw a resultant? and that its magnitude would be 72 N, given by the box hanging from it. and from there do Opp/hyp or Sin (60).
-----ceiling----------
\ 60) | (60 /
\ | /
\ | /
B \ | / C
\ | /
\ |/
[_]



Any help would be appreciated! thanks

 
Physics news on Phys.org
The figure is supposed to be an a triangle with its base parallel with the ceiling and its other two sides pointing into a V .
 
For cable A try thinking of the small box as a "ceiling" with only cable A below it and from that cable, the large box would be hanging. What would you say the tension is in that situation? Is this situation any different?

For part (b) don't forget that you need to include both the small box's weight (force) AND the large box's weight (force).
 
1. So to find the tension in Cable A, I take the 72 N pointing down, and the 150 N pointing up, and get a net force of 78 N. Would that be correct. I feel confused into thinking that the sum of forces should be zero if these boxes are hanging in equilibrium.?

2. 72 N + 150 N= 222N(sin(60))= 192 N the tension in cable B!>??
 
valeriex0x said:
1. So to find the tension in Cable A, I take the 72 N pointing down, and the 150 N pointing up, and get a net force of 78 N. Would that be correct. I feel confused into thinking that the sum of forces should be zero if these boxes are hanging in equilibrium.?

2. 72 N + 150 N= 222N(sin(60))= 192 N the tension in cable B!>??

I guess I wasn't clear enough. For part (a), nothing is moving. Because nothing is moving, the only "force" being applied on the lower string is that of the large box. It is the same as if the large box were hanging from the ceiling from cable A and you were asked what the tension is in that cable.

For part 2, don't forget that you have 2 cables. Would cable B be taking all the load? Think of what you can do to take advantage of the geometry in the problem.
 
1. The tension in Cable A is 150 N.
2. The tension in Cable B=Cable C = 128 N.

2) 72 N + 150 N= 222 N
Sin(60)= opp/hyp=222N/x=.8660254
Put sin(60) over one, cross multiply, solve for x (Cable B) x= 256 N

but that is the total tension.

Total Tension 256N divide by 2 = 128N tension in cable b and c

??! I think i got it!
 
TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...
Thread 'Variable mass system : water sprayed into a moving container'
Starting with the mass considerations #m(t)# is mass of water #M_{c}# mass of container and #M(t)# mass of total system $$M(t) = M_{C} + m(t)$$ $$\Rightarrow \frac{dM(t)}{dt} = \frac{dm(t)}{dt}$$ $$P_i = Mv + u \, dm$$ $$P_f = (M + dm)(v + dv)$$ $$\Delta P = M \, dv + (v - u) \, dm$$ $$F = \frac{dP}{dt} = M \frac{dv}{dt} + (v - u) \frac{dm}{dt}$$ $$F = u \frac{dm}{dt} = \rho A u^2$$ from conservation of momentum , the cannon recoils with the same force which it applies. $$\quad \frac{dm}{dt}...
Back
Top