Using Solar panels for energy conversion?

AI Thread Summary
The discussion focuses on using solar panels to power Bluetooth noise-cancellation headphones, emphasizing the need for clarity on power consumption and voltage requirements. Participants suggest starting with specific power consumption data to determine the appropriate solar panel size and type. Simple photovoltaic cells that produce USB 5V outputs are recommended for their compatibility with charging devices. Understanding how these panels convert variable output voltage into a stable supply is crucial for the project. Overall, the conversation highlights the importance of matching solar panel specifications to the headphones' energy needs.
GrandioseNigma
Messages
2
Reaction score
0
Hi guys I am working on a project in which i use solar panels to drive a pair of headphones

my main question is what kind of solar panels would you guys recommend? that could help with this kind of project
 
Engineering news on Phys.org
The question is way too vague for a specific answer. What do the headphones do? Just powering them without some source of sound would be quite pointless.
 
mfb said:
The question is way too vague for a specific answer. What do the headphones do? Just powering them without some source of sound would be quite pointless.
their basic bluetooth/noise cancellation headphones, the project is to use solar energy as an alternative to charging/powering up the battery without the need for an electrical outlet
 
GrandioseNigma said:
their basic bluetooth/noise cancellation headphones, the project is to use solar energy as an alternative to charging/powering up the battery without the need for an electrical outlet
So start with your power consumption numbers. What voltage do they require? What power do they consume?

Then look at simple photovoltaic cells, and see how big it will have to be to produce that power in whatever sunlight conditions you expect. I'm guessing you can find some existing panels that produce USB 5V outputs of a few watts in reasonable sunlight conditions. Start by checking them out, and understanding how they convert the variable output voltage of PV cells (for different light levels) into a constant voltage for powering the loads... :smile:
 
I use something like this to recharge my phone and my ipad. If your headphones charge with USB, this might work.

https://www.amazon.com/dp/B012CX3Z2C/?tag=pfamazon01-20
 
Last edited by a moderator:
Very basic question. Consider a 3-terminal device with terminals say A,B,C. Kirchhoff Current Law (KCL) and Kirchhoff Voltage Law (KVL) establish two relationships between the 3 currents entering the terminals and the 3 terminal's voltage pairs respectively. So we have 2 equations in 6 unknowns. To proceed further we need two more (independent) equations in order to solve the circuit the 3-terminal device is connected to (basically one treats such a device as an unbalanced two-port...
suppose you have two capacitors with a 0.1 Farad value and 12 VDC rating. label these as A and B. label the terminals of each as 1 and 2. you also have a voltmeter with a 40 volt linear range for DC. you also have a 9 volt DC power supply fed by mains. you charge each capacitor to 9 volts with terminal 1 being - (negative) and terminal 2 being + (positive). you connect the voltmeter to terminal A2 and to terminal B1. does it read any voltage? can - of one capacitor discharge + of the...
Thread 'Weird near-field phenomenon I get in my EM simulation'
I recently made a basic simulation of wire antennas and I am not sure if the near field in my simulation is modeled correctly. One of the things that worry me is the fact that sometimes I see in my simulation "movements" in the near field that seems to be faster than the speed of wave propagation I defined (the speed of light in the simulation). Specifically I see "nodes" of low amplitude in the E field that are quickly "emitted" from the antenna and then slow down as they approach the far...
Back
Top