Van de Graaff generator questions?

AI Thread Summary
A Van de Graaff generator charged to 50,000 volts requires approximately 8.0 x 10^{-15} J of energy to add an additional electron. The discussion reveals confusion regarding the relationship between voltage and capacitance, with the realization that increasing the radius of the generator increases capacitance, which can lower voltage. It is clarified that larger generators can hold more charge, potentially resulting in higher voltage despite increased capacitance. The textbook's statement about increasing voltage by enlarging the sphere is deemed misleading, suggesting it should refer to capacitance instead. The conversation highlights the need for better educational resources on capacitance in the context of Van de Graaff generators.
AFSteph
Messages
17
Reaction score
0
Hello~ I've got a confusing question;

"If a Van de Graaff generator is charged to 50,000 volts, how much energy does it take to add an additional electron to the charge on the sphere?"
(The charge of an electron is given as -1.6 x 10^{-19}C)
My answer: (50,000 V)( -1.6 x 10^{-19}C) = 8.0 x 10^{-15} J
Er, I actually don't understand this at all, but if it's correct then meh.

Second question:
"How would the voltage of the generator in Part (A) compare to the voltage of a larger Van de Graaff generator with the same amount of charge? To which generator could an electron be added with the least expenditure of energy?"
According to my textbook,
The voltage of a Van de Graaff generator can be increased by increasing the radius of the sphere or by placing the entire system in a container filled with high pressure gas.
So then by that reasoning, the larger generator should have more voltage for the same amount of charge. And by using the formula of volts x charge of an electron to find the energy needed to add an electron then it should take more energy to add to the bigger, higher voltage, generator.

BBUUUUUUUUTT... this is a bit contradictory to me because here https://www.physicsforums.com/showthread.php?t=229046 Doc Al has a different (opposite!) answer that makes sense but doesn't fit.

Can someone help me in clear English here? Thanks for any assistance!
 
Physics news on Phys.org
Q = CV.
If Q stays constant and C increases, what does V do? Then what does qV do?

(Note: the capacitance of a sphere = 4 pi epsilon R, R = radius of sphere. Adding the gas also increases C).
 
Last edited:
rude man said:
Q = CV.
If Q stays constant and C increases, what does V do? Then what does qV do?

(Note: the capacitance of a sphere = 4 pi epsilon R, R = radius of sphere. Adding the gas also increases C).
Hmm maybe I should mention that the course I'm doing is a conceptual Physics one and we don't learn JACK about the mathematical side of things. "Q = CV" is nowhere in my textbook so I guess I've got some googling to do... Thanks for your input :D
 
Q = CV
Where Q is charge; C is capacitance and V is voltage.
So I think I know what you're saying... I had capacitance and voltage a bit backwards here.

So as the radius increases, capacitance, not voltage, increases and the voltage decreases. And by that formula given earlier, (voltage x electron charge) with less voltage it is easier to add an extra electron. That makes a lot more sense now :D

Thank goodness for the internet because this textbook really is not that helpful. They don't give the formula for capacitance nor do they even mention the frickin' word capacitance in the chapter on Van de Graaff generators!

If I'm understanding this correctly, then the quote in my textbook is incorrect
The voltage of a Van de Graaff generator can be increased by increasing the radius of the sphere or by placing the entire system in a container filled with high pressure gas.
The word "voltage" should be replaced with the word "capacitance", no?

Am I understanding this correctly?
 
AFSteph said:
Q = CV
Where Q is charge; C is capacitance and V is voltage.
So I think I know what you're saying... I had capacitance and voltage a bit backwards here.

So as the radius increases, capacitance, not voltage, increases and the voltage decreases. And by that formula given earlier, (voltage x electron charge) with less voltage it is easier to add an extra electron. That makes a lot more sense now :D

Thank goodness for the internet because this textbook really is not that helpful. They don't give the formula for capacitance nor do they even mention the frickin' word capacitance in the chapter on Van de Graaff generators!

If I'm understanding this correctly, then the quote in my textbook is incorrect

The word "voltage" should be replaced with the word "capacitance", no?

Am I understanding this correctly?

You are doing fine.

But your textbook could still be right: the larger generators can probably hold much more charge so even though the capacitance is higher, you can add even more Q with the result that the voltage is higher also than on a smaller unit. Nevertheless, I find the statement confusing at best.
 
I believe the statement in the book has to do with electrical breakdown or perhaps corona discharge. Voltages in van der Graaff generators are limited by that.
 
voko said:
I believe the statement in the book has to do with electrical breakdown or perhaps corona discharge. Voltages in van der Graaff generators are limited by that.
That was my impression as well.

More modern Van de Graaff generators are insulated by pressurized dielectric gas, usually freon or sulfur hexafluoride.

http://en.wikipedia.org/wiki/Robert_J._Van_de_Graaff
 
rude man said:
You are doing fine.

But your textbook could still be right: the larger generators can probably hold much more charge so even though the capacitance is higher, you can add even more Q with the result that the voltage is higher also than on a smaller unit. Nevertheless, I find the statement confusing at best.

Thank you so much for clarifying. The course I'm doing is the American School of Correspondence's Conceptual Physics course, which is meant for homeschooled students (as I am).

They develop the exams and "study guide" themselves, and they obviously have no influence on the course book -- they just built around it. That said, it seems bizarre that they would ask a question when the course book would lead you to a contradictory answer. When I mail off this exam (correspondence course -- things are sent though the mail) should I include a letter with a link to this thread suggesting they have a section in the study guide on capacitance clarifying this? Seems like legitimate constructive criticism / feedback.

Again, thank you for helping me through this. I appreciate the hinting approach :)
 
  • #10
AFSteph said:
Thank you so much for clarifying. The course I'm doing is the American School of Correspondence's Conceptual Physics course, which is meant for homeschooled students (as I am).

They develop the exams and "study guide" themselves, and they obviously have no influence on the course book -- they just built around it. That said, it seems bizarre that they would ask a question when the course book would lead you to a contradictory answer. When I mail off this exam (correspondence course -- things are sent though the mail) should I include a letter with a link to this thread suggesting they have a section in the study guide on capacitance clarifying this? Seems like legitimate constructive criticism / feedback.

Again, thank you for helping me through this. I appreciate the hinting approach :)

I would think that's a good idea.
 
  • #11
voko said:
I believe the statement in the book has to do with electrical breakdown or perhaps corona discharge. Voltages in van der Graaff generators are limited by that.

Yes it's to do with electric field strength ( E=-V/r r= radius of dome). If this exceeds a certain value(I think its between 3MV to 4MV for dry air at normal pressure )the air breaks down and you get sparking. Of course the dome is not perfectly spherical and there are smaller radii bits surrounding the hollow where the support and the belt enter. The field is stronger at these more "pointy bits".
 
  • #12
Dadface said:
Yes it's to do with electric field strength ( E=-V/r r= radius of dome). If this exceeds a certain value(I think its between 3MV to 4MV for dry air at normal pressure )

I assume you wanted to say MV/m, not just MV.
 
  • #13
voko said:
I assume you wanted to say MV/m, not just MV.
Yes, thanks for pointing that out.
 
Back
Top