What are the methods for solving impulse and momentum problems?

  • Thread starter Thread starter mikejones2000
  • Start date Start date
AI Thread Summary
The discussion focuses on solving two impulse and momentum problems. The first problem involves calculating the mass of a baseball after being hit by a bat, using the impulse-momentum theorem. The second problem requires determining the impulse delivered to a ball from a force vs. time graph, suggesting the use of the area of a triangle for approximation. Participants confirm that the methods proposed for both problems are correct, emphasizing the importance of using appropriate units and vector quantities. Overall, the thread highlights the application of impulse and momentum principles in practical scenarios.
mikejones2000
Messages
18
Reaction score
0
I am currently stuck on two problems:
#1 A bat hits a moving baseball. If the bat delivers a net eastward impulse of 0.9 N-s and the ball starts with an initial horizontal velocity of 3.8 m/s to the west and leaves with a 5.3 m/s velocity to the east, what is the mass of the ball (in grams)?

I set J=deltaP
.9=95.3+3.8)m
m=.9/(5.3+3.8).

#The second problem has a force vs. time for an impulsive force graph and asks: The force shown in the figure below is the net eastward force acting on a ball. The force starts rising at t=0.012 s, falls back to zero at t=0.062 s, and reaches a maximum force of 35 N at the peak. Determine with an error no bigger than 25% (high or low) the magnitude of the impulse (in N-s) delivered to the ball. Hint: Do not use J = FΔt. Look at the figure. Find the area of a nearly equally sized triangle.

I am sure tthis problem is very simple but do not have a confident approach for some reason, I presume I find the time when it peaks at 35 N(.062-.012) and use this as my base? Then I would apply A=.5(35)(.062-.012)?

Any help would be greatly appreciated.
 
Physics news on Phys.org
It seems like you methods are correct, is there a problem with you answers?

Also if this graph is the graph for the basball and bat in part one the area of your approximate triangle should be approximately .9Ns
 
I got 0.0989 for the first problem, I am not sure if its in kilograms or grams and
0.875 for the second one. I know I got at least one problem out of the three assigned and presume it has to be one of these because the other is a multiple choice problem. Thanks in advance for any help.
 
If you're using SI units for your working it will be Kg.

With regards to question 1 remember that delta p is pf - pi. Also these are vector quantities but I think you've taken that into account just a reminder.

For question 2 if they say use a triangle then use a triangle it should be fine. The area under the curve would normally be determined by the integral of F(t) but since its not given the triangle method should give a fair approximation.
 
Last edited:
I multiplied the values first without the error limit. Got 19.38. rounded it off to 2 significant figures since the given data has 2 significant figures. So = 19. For error I used the above formula. It comes out about 1.48. Now my question is. Should I write the answer as 19±1.5 (rounding 1.48 to 2 significant figures) OR should I write it as 19±1. So in short, should the error have same number of significant figures as the mean value or should it have the same number of decimal places as...
Thread 'A cylinder connected to a hanging mass'
Let's declare that for the cylinder, mass = M = 10 kg Radius = R = 4 m For the wall and the floor, Friction coeff = ##\mu## = 0.5 For the hanging mass, mass = m = 11 kg First, we divide the force according to their respective plane (x and y thing, correct me if I'm wrong) and according to which, cylinder or the hanging mass, they're working on. Force on the hanging mass $$mg - T = ma$$ Force(Cylinder) on y $$N_f + f_w - Mg = 0$$ Force(Cylinder) on x $$T + f_f - N_w = Ma$$ There's also...
Back
Top