What's Your Coolest 555 Timer Project?

  • Thread starter Thread starter d1983
  • Start date Start date
AI Thread Summary
The discussion centers around creative projects utilizing the 555 timer, highlighting various innovative applications. One user designed a brake/blinker system with high-intensity LEDs, while another shared a humorous experience of creating a variable speed blinking LED display. Additional projects mentioned include an automatic car starter that cranks the engine for a set duration and a narrow band frequency detector using dual 555 timers. Another user humorously noted using a 555-like chip to stabilize a drafting table. The thread showcases the versatility and fun of 555 timer projects.
d1983
Messages
6
Reaction score
0
I have just designed a brake/blinker system using high intensity LEDs and a 555 timer and it gave me an idea for a post:
What's the coolest thing you've done using a 555 timer?
 
Engineering news on Phys.org
On work experience as boy i made a Variable speed blinking LED display with an offensive message. And i placed it above the bosses office door for giggles.
 
I made an automatic car starter with a monostable 555. At the touch of a button it would crank the engine over for 3 seconds unless it started sooner, in which case it would stop cranking. Pretty click and neat !
 
I made a narrow band frequency detector by using 2 555s as missing pulse detectors.
 
555

Like The car starter, I made an adjustable jacobs later using an ignition coil
 
I know nothing of electronics, but I did once use a chip that looked very much like a 555 to prop up the short leg of my draughting table. Does that count? :confused:
 
Very basic question. Consider a 3-terminal device with terminals say A,B,C. Kirchhoff Current Law (KCL) and Kirchhoff Voltage Law (KVL) establish two relationships between the 3 currents entering the terminals and the 3 terminal's voltage pairs respectively. So we have 2 equations in 6 unknowns. To proceed further we need two more (independent) equations in order to solve the circuit the 3-terminal device is connected to (basically one treats such a device as an unbalanced two-port...
suppose you have two capacitors with a 0.1 Farad value and 12 VDC rating. label these as A and B. label the terminals of each as 1 and 2. you also have a voltmeter with a 40 volt linear range for DC. you also have a 9 volt DC power supply fed by mains. you charge each capacitor to 9 volts with terminal 1 being - (negative) and terminal 2 being + (positive). you connect the voltmeter to terminal A2 and to terminal B1. does it read any voltage? can - of one capacitor discharge + of the...
Thread 'Weird near-field phenomenon I get in my EM simulation'
I recently made a basic simulation of wire antennas and I am not sure if the near field in my simulation is modeled correctly. One of the things that worry me is the fact that sometimes I see in my simulation "movements" in the near field that seems to be faster than the speed of wave propagation I defined (the speed of light in the simulation). Specifically I see "nodes" of low amplitude in the E field that are quickly "emitted" from the antenna and then slow down as they approach the far...
Back
Top