Why do electrical generators experience load effects?

AI Thread Summary
Electrical generators experience load effects because the load current creates a torque that counteracts the mechanical input torque, resulting in a decrease in generator efficiency. This phenomenon is a result of the motor action inherent in generators, as they function similarly to motors under load. When multiple generators are used to share the load, the division of torque can potentially reduce the overall drag on the system, although the total energy output remains constant due to the conservation of energy principle. Understanding these dynamics is crucial for optimizing generator performance under varying load conditions. Ultimately, effective management of load distribution can enhance generator efficiency.
Bloc911
Messages
9
Reaction score
0
I was wondering why it is when you use the electricity from an electrical generator, it bogs the generator down? Shouldn't the draw off of electricity negate any sort of back flow there by making it easier on the generator to function?
 
Engineering news on Phys.org
Conservation of energy is immutable. When the generator is loaded, the load current produces a torque which counters the input mechanical torque. This is motor action. Generators are motors as well, & vice-versa.

Claude
 
Ty cabraham, I will soon be working a generator system and was curious about the effects of loading on generators. I had guessed that such was the case but figured it would be better to ask. Hopefully soon I will be able to set my system. From the figures is have been working with I should be in the clear on the power to crank the generators under load as I will have 5 generators to split the load. Hopefully dividing the torque between them should be such that even though it will still be the same overall amount the division will produce less drag on the whole. I am guessing anyway. I will have to wait until I get it up and running to test it out.
 
Just note that no matter what, the system will obey Conservation of Energy.
 
Noted ty.
 
Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
Back
Top