Why photodiode is operated in reverse bias?

AI Thread Summary
Photodiodes are operated in reverse bias to widen the depletion region, allowing for more efficient collection of electron-hole pairs generated by incoming light. In reverse bias, only the charges generated within the depletion region contribute to the current, enhancing sensitivity. Forward bias reduces the depletion layer, decreasing sensitivity and increasing the forward current, which overshadows the photocurrent. While photodiodes can operate without bias, their efficiency is significantly lower compared to reverse bias operation. Overall, reverse bias is crucial for maximizing the performance of photodiodes in light detection applications.
hanii
Messages
24
Reaction score
0
why photodiode is operated in reverse bias??

can anyone please explain why photodiode is operated only in reverse bias?? can we operate it forward bias state also??
 
Last edited:
Physics news on Phys.org


Good question. I think it's because when reverse biased the depletion region becomes wider. Only electron-hole pairs that are generated in the depletion region (or within a diffusion length of the depletion region) will be swept across the junction and contribute to reverse current. So having a large depletion region is beneficial. You can also operate the PD with no bias but it will not be as efficient.

-Matt Leright
 


so if we operate it in forward bias...the depletion layer length would be less compared to that as in reverse biased condition...there by reducing its sensitivity . why only the depletion layer is exposed to light... not all the device..?
 


hanii said:
so if we operate it in forward bias...the depletion layer length would be less compared to that as in reverse biased condition...there by reducing its sensitivity . why only the depletion layer is exposed to light... not all the device..?

yes. Plus I think the forward bias current is much higher than the photocurrent generated.

The reason only ehps generated in the depletion region (or very close to the depletion region) contribute to current is because those are the ehps that are in an electric field. Remember the region where there is a slope in the band diagram there is an e-field. the flat regions there is no field so no current.
 


so biasing only helps to improve the reverse current ...?? if it is so...can we get the reverse current flow through the load and produce potential difference across it without biasing the diode...??
 


hanii said:
so biasing only helps to improve the reverse current ...?? if it is so...can we get the reverse current flow through the load and produce potential difference across it without biasing the diode...??

The PD will have some reverse current when light is shined on it with no bias, yes.

-Matt
 
I think it's easist first to watch a short vidio clip I find these videos very relaxing to watch .. I got to thinking is this being done in the most efficient way? The sand has to be suspended in the water to move it to the outlet ... The faster the water , the more turbulance and the sand stays suspended, so it seems to me the rule of thumb is the hose be aimed towards the outlet at all times .. Many times the workers hit the sand directly which will greatly reduce the water...
Back
Top