Young's Modulus of Wire with 0.94 kN Load

AI Thread Summary
The discussion focuses on calculating the Young's modulus of a wire subjected to a 0.94 kN load. The wire, measuring 4.95 m in length and with a cross-sectional area of 0.103 cm², stretches by 6.55 mm under the load. Initial calculations yielded a Young's modulus of approximately 71.78 Pa, which was identified as incorrect. The correct formula application led to a revised Young's modulus of approximately 6.90 × 10^10 Pa. The final calculation was confirmed as accurate by participants in the discussion.
mikefitz
Messages
155
Reaction score
0
A wire of length 4.95 m with a cross-sectional area of 0.103 cm^2 stretches by 6.55 mm when a load of 0.94 kN is hung from it. What is the Young's modulus for this wire?

FA = Y (delta L/L)

0.103 (cm^2) = 1.03 × 10-5 m^2
6.55 millimeters = 0.00655 meters

= 9221.4 N x 1.03 × 10-5 m^2 = .09498

0.00655m / 4.95m = 0.00132323232
.09498 / 0.00132323232 = 71.7787788 Pa ?

what did i do wrong?
 
Physics news on Phys.org
\Delta l = \frac{Fl}{YA} \Rightarrow Y = \frac{Fl}{\Delta l A}.
 
Y = 940N * 4.95m
------------
.00655m * 1.03(10^-5)m^2

Y = 6.90356083 × 10^10

Does this seem correct? thanks for the help
 
Yes, it seems correct.
 
Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...
Back
Top