How can i dispose of chemicals safely

  • Thread starter Thread starter lprekon
  • Start date Start date
  • Tags Tags
    Chemicals
AI Thread Summary
When starting a chemistry hobby, understanding safe chemical disposal is crucial. It's important to find a reliable and affordable hazardous materials disposal company, as some may even pay for waste if they can recycle it. Determining safe disposal methods often depends on the specific chemicals involved; for example, aluminum cans are not disposed of the same way as hazardous substances like dioxins. Converting waste into a safe form for disposal is also a consideration, but it requires knowledge of the specific chemicals. Overall, detailed information about the types of waste is necessary to provide accurate disposal guidance.
lprekon
Messages
6
Reaction score
0
I have recently gotten fascinated with chemistry, and I am looking to start it as a hobby. However one, of the things I want to have under control before i start is chemical disposal. Does anyone know a good cheap company I can hire for hazardous materials disposal? I have heard from a printer friend of mine that there are companies who will even pay for the waste because they re-purpose/recycle it.
Or, is there a way of determining what is and isn't safe to dispose of down the drain? Could I convert whatever waste I have back into a safe form and dispose of it that way?

Any information would be helpful
 
Chemistry news on Phys.org
Waste disposal is specific to the waste in question. Would you dispose of aluminum cans the same way you would dioxin?

Nobody can answer your question without specifics.
 
I want to test a humidity sensor with one or more saturated salt solutions. The table salt that I have on hand contains one of two anticaking agents, calcium silicate or sodium aluminosilicate. Will the presence of either of these additives (or iodine for that matter) significantly affect the equilibrium humidity? I searched and all the how-to-do-it guides did not address this question. One research paper I found reported that at 1.5% w/w calcium silicate increased the deliquescent point by...
I'm trying to find a cheap DIY method to etch holes of various shapes through 0.3mm Aluminium sheet using 5-10% Sodium Hydroxide. The idea is to apply a resist to the Aluminium then selectively ablate it off using a diode laser cutter and then dissolve away the Aluminium using Sodium Hydroxide. By cheap I mean resists costing say £20 in small quantities. The Internet has suggested various resists to try including... Enamel paint (only survived seconds in the NaOH!) Acrylic paint (only...
Back
Top