Can water be instantly vaporized without reaching its boiling point?

AI Thread Summary
The discussion centers around the concept of a jet pack that utilizes steam for propulsion, recalling a military invention. The original poster seeks clarification on whether there exists a liquid that can be combined with water to cause it to vaporize without reaching its boiling point. The response highlights that while adding low boiling liquids like ethanol can lower the boiling point of water, it does not lead to vaporization without sufficient energy. The conversation suggests that concentrated hydrogen peroxide (H2O2) could be a potential candidate, as its decomposition, when catalyzed, produces steam and oxygen, and can be explosive if contained.
GTeclips
Messages
23
Reaction score
0
Hello,

I recall watching a show that discussed several personal flying devise the military had invented over the years. One of them was the Hiller's flying platform, but there was another that they mentioned. It was a jet pack of sorts (I can't recall it's name) and it used steam. I don't know if I remember how it worked, but if I am right, it would combine water and some other substance and the water would instantly vaporize.

I'm not as much interested in a reference as to what the jet pack was called or if I misunderstood how it worked (Although I probably did). I wish to know if there is some liquid that can be combined with water to vaporize it without reaching it's boiling point?

Thank you.
 
Chemistry news on Phys.org
You can lower the boiling point by adding other low boiling liquid (like ethanol for example), but it won't vaporize the water. For that you need a lot of energy, regardless of the temperature.
 
I suspect it was concentrated H2O2. A catalyst triggered decomposition of Hydrogen peroxide can be very violent (even explosive if confined). The products are H2O (steam if hot enough) and O2, basically non-toxic.
 
I want to test a humidity sensor with one or more saturated salt solutions. The table salt that I have on hand contains one of two anticaking agents, calcium silicate or sodium aluminosilicate. Will the presence of either of these additives (or iodine for that matter) significantly affect the equilibrium humidity? I searched and all the how-to-do-it guides did not address this question. One research paper I found reported that at 1.5% w/w calcium silicate increased the deliquescent point by...
I'm trying to find a cheap DIY method to etch holes of various shapes through 0.3mm Aluminium sheet using 5-10% Sodium Hydroxide. The idea is to apply a resist to the Aluminium then selectively ablate it off using a diode laser cutter and then dissolve away the Aluminium using Sodium Hydroxide. By cheap I mean resists costing say £20 in small quantities. The Internet has suggested various resists to try including... Enamel paint (only survived seconds in the NaOH!) Acrylic paint (only...
Back
Top