A way to send and receive wireless data

  • Thread starter Thread starter ahmadicabara
  • Start date Start date
  • Tags Tags
    Data Wireless
AI Thread Summary
Transmitting and receiving 100,000 signals per second over a distance of 30 km is a challenging task. Current technologies like cell phone text messaging may not meet the speed and cost requirements specified. Alternatives such as advanced radio frequency systems or dedicated wireless networks could potentially achieve the desired performance. However, achieving simultaneous decoding of 100-character messages from that many transmitters within one second remains complex. Exploring specialized communication protocols or technologies may be necessary for this application.
ahmadicabara
Messages
9
Reaction score
0
Hi,

What can I use to transmit and receive data wirelessly from let's say 100K receiver every sec located at 30 Km Max. Every transmitter is sending 100 char every sec. Is this even possible?Regards,
 
Engineering news on Phys.org
Thanks for your reply but I was thinking faster and cheaper way to receive 100k signals all at once and decode them in 1 sec (assuming that each signal has 100 char each)
 
Hi all, I have a question. So from the derivation of the Isentropic process relationship PV^gamma = constant, there is a step dW = PdV, which can only be said for quasi-equilibrium (or reversible) processes. As such I believe PV^gamma = constant (and the family of equations) should not be applicable to just adiabatic processes? Ie, it should be applicable only for adiabatic + reversible = isentropic processes? However, I've seen couple of online notes/books, and...
Thread 'How can I find the cleanout for my building drain?'
I am a long distance truck driver, but I recently completed a plumbing program with Stratford Career Institute. In the chapter of my textbook Repairing DWV Systems, the author says that if there is a clog in the building drain, one can clear out the clog by using a snake augur or maybe some other type of tool into the cleanout for the building drain. The author said that the cleanout for the building drain is usually near the stack. I live in a duplex townhouse. Just out of curiosity, I...
I have an engine that uses a dry sump oiling system. The oil collection pan has three AN fittings to use for scavenging. Two of the fittings are approximately on the same level, the third is about 1/2 to 3/4 inch higher than the other two. The system ran for years with no problem using a three stage pump (one pressure and two scavenge stages). The two scavenge stages were connected at times to any two of the three AN fittings on the tank. Recently I tried an upgrade to a four stage pump...
Back
Top