Air pressure caused by wind on human being

AI Thread Summary
The discussion focuses on calculating the air pressure exerted by wind on a human body at various speeds. A formula is provided: P = 0.00256 x V^2 x C, where P is pressure in psi, V is wind velocity in mph, and C is a shape coefficient. The complexity of the human body's shape makes determining an accurate coefficient challenging. One participant suggests starting the calculations without the shape coefficient, noting that maximum pressure occurs at the stagnation point on the body. The conversation emphasizes the need for further exploration of the shape coefficient for precise calculations.
mjdwyer23
Messages
4
Reaction score
0
Hi Folks-
Is there a way to determine the air pressure caused by wind at a given mph on a human being? Thanks!

MD
 
Physics news on Phys.org
mjdwyer23 said:
Hi Folks-
Is there a way to determine the air pressure caused by wind at a given mph on a human being? Thanks!

MD

Yes. The general formula for your units is:

P = 0.00256 x V^2 x C

where,

P is the pressure in psi
V is the wind velocity in mph
C is a shape coefficient (don't know what it would be for a human body since it is such a complex shape)

Hope this helps.

CS
 
Thanks for the quick response! I'll do some more digging on the shape part and see what I can come up with. Thanks again!
 
I'd start without the shape coefficient - there is a point in the middle of your body where the air stagnates, producing the maximum pressure possible via Bernoulli's equation.
 
Thread 'Is 'Velocity of Transport' a Recognized Term in English Mechanics Literature?'
Here are two fragments from Banach's monograph in Mechanics I have never seen the term <<velocity of transport>> in English texts. Actually I have never seen this term being named somehow in English. This term has a name in Russian books. I looked through the original Banach's text in Polish and there is a Polish name for this term. It is a little bit surprising that the Polish name differs from the Russian one and also differs from this English translation. My question is: Is there...
Thread 'Beam on an inclined plane'
Hello! I have a question regarding a beam on an inclined plane. I was considering a beam resting on two supports attached to an inclined plane. I was almost sure that the lower support must be more loaded. My imagination about this problem is shown in the picture below. Here is how I wrote the condition of equilibrium forces: $$ \begin{cases} F_{g\parallel}=F_{t1}+F_{t2}, \\ F_{g\perp}=F_{r1}+F_{r2} \end{cases}. $$ On the other hand...
Back
Top