Are There Quantum-Level Alternatives to Traditional Power Generation?

  • Thread starter Thread starter koab1mjr
  • Start date Start date
  • Tags Tags
    Cycles
AI Thread Summary
Research into quantum-level alternatives to traditional power generation is ongoing, with a focus on energy harvesting at the atomic level. The discussion highlights the limitations of conventional methods like boilers and turbines, which primarily rely on thermal energy. There is interest in exploring more efficient systems that could harness mechanical energy directly from quantum processes, potentially reducing waste and environmental impact. While nuclear power is mentioned as a form of quantum energy generation, the conversation seeks fundamentally different approaches, akin to large-scale photovoltaics. The quest for innovative power generation methods continues to be a significant area of interest in power engineering.
koab1mjr
Messages
105
Reaction score
0
I am plowing away through my ME curriculum and my intentions is to go into power engineering in some shape or form. I wanted to know if any research has gone into energy harvesting at a atomic level. I just wondered if any research has gone into alternative to a boiler and a turbine for generation since that is really what all power generation boils down to at a basic level. Is there any research in gathering mechanical energy at a quantum level rather than trying to play with chaotic heat?
 
Engineering news on Phys.org
Are you asking whether there are other ways to generate power other than thermal? Thats what I gather, since nuclear power is "gathering mechanical energy at a quantum level", but it's still just a glorified boiler/steam turbine system.

Whats so bad about "chaotic heat", anyway?
 
Well I know about the nuclear route and I like it but i was wondering if anyone is doing something fundamentally different. Like photovoltaics but on a grander scale. Its just that heat is so wasteful and has negative consequences on the environment where as somehow taping the mechanical energy at atomic level would allow for substantial higher efficiencies. I just wondering if anything is going on looking for another way...
 
Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'
Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
Back
Top