Bolt falls off rocket, find rocket acceleration

AI Thread Summary
A rocket is launched with constant acceleration, and a bolt falls off four seconds after liftoff, hitting the ground 6.7 seconds later. To find the rocket's acceleration, the height the bolt falls from must first be calculated using the equation d = v_{i}t + 1/2at^2, with initial velocity set to zero. After determining the height and speed of the rocket at four seconds, these values are used to establish the bolt's motion after it detaches. The final equation for the bolt's height incorporates the rocket's initial height and speed, allowing for the calculation of the rocket's acceleration. This methodical approach leads to the solution for the rocket's acceleration.
stangeroo
Messages
13
Reaction score
0
A rocket is launched straight up with constant acceleration. Four seconds after liftoff, a bolt falls off the side of the rocket. The bolt hits the ground 6.70 s later.

Find the rockets acceleration.

I don't understand how to set up this problem, I've never done something like this , asked some friends and they didnt know how to do it. Any help would be greatly appreciated :smile:
 
Physics news on Phys.org
Work backwards kind of. If it took 6.7 for the bolt to hit the ground, how high was it?

d = v_{i}t + \frac{1}{2}at^2

vi = 0
a = -32 ft\sec^2 or -9.8 m\sec^2
t = 6.7 s

Solve for d.

Now, use the same equation and solve for "a" of the rocket.

d = v_{i}t + \frac{1}{2}at^2

d = part a
vi = 0
t = 4


Jameson
 
Do it in two parts, but like this:
Part 1: Find the height and speed of the rocket after 4 seconds in terms of the rocket acceleration. Use:
h = 1/2 a t^2 and
v = a t

Part 2: Realize that the initial height and speed of the bolt equals the height and speed of the rocket after 4 seconds (which was calculated in part 1). The height of the bolt after it leaves the rocket is:
h = h_0 + v_0t -(g/2)t^2,
using h_0 and v_0 (in terms of a) from part 1; set h = 0 when t = 6.7 seconds. Solve for a.
 
thank you guys:cool:
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Trying to understand the logic behind adding vectors with an angle between them'
My initial calculation was to subtract V1 from V2 to show that from the perspective of the second aircraft the first one is -300km/h. So i checked with ChatGPT and it said I cant just subtract them because I have an angle between them. So I dont understand the reasoning of it. Like why should a velocity be dependent on an angle? I was thinking about how it would look like if the planes where parallel to each other, and then how it look like if one is turning away and I dont see it. Since...
Back
Top