Can I Create a 15 Degree Phase Shift with Transformers?

AI Thread Summary
To achieve a 15-degree phase shift using transformers, a regulated voltage can be added to the phase-to-neutral voltage at the source terminal. This method involves using a winding in series with a network branch to insert the regulated voltage, which influences the direction of active power flow between transformer terminals. Delta-wye transformers typically create a 30-degree phase shift, but adjustments can be made for smaller shifts. Phase shifting transformers, while expensive, are essential for managing real power flow in electrical grids. Various methods and circuit diagrams for implementing phase shifts are available in specialized resources.
kper
Messages
1
Reaction score
0
I was wondering how I can get a 15 degree phase shift with transformers. I know a delta wye transformer creates a 30 degree phase shift.
 
Engineering news on Phys.org
kper said:
I was wondering how I can get a 15 degree phase shift with transformers. I know a delta wye transformer creates a 30 degree phase shift.

The change in phase angle between the terminal voltages of the transformer unit is carried out by
adding a regulated voltage to the phase-to-neutral voltage at the source terminal.
A winding in series with a network branch is used to insert the regulated voltage that, when added
with the appropriate phase to the source terminal phase-to-neutral voltage,
sets up the desired direction of the active power flow between the transformer terminals.

the circuit diagram and a few methods for phase sifting can be seen at
Ref: https://ewh.ieee.org/soc/pes/newyork/NewSite/PDFs/Protection%20Related/Phase_Shifting_Transformer_Modeling.pdf
 
  • Like
Likes anorlunda
drvrm told you about phase shifting transformers. Those things are expensive, but incredibly useful devices at key points in the grid. Remember that real power flow depends on angle, so shifting phase controls real power flow.

The picture below shows a simple way to make a non-adjustable phase shift on a delta winding. Just tap the output at different points.

Power%2BTransformers%2BPrinciples%2Band%2BApplications%2B3.bmp.jpg
 
Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
Back
Top