Car Velocity After Engine Cuts Out | Physics Problem

  • Thread starter Thread starter Cursed
  • Start date Start date
  • Tags Tags
    Velocity
AI Thread Summary
A car traveling at +31.0 m/s experiences an engine failure, leading to a deceleration over two intervals: the first lasting ten seconds with average acceleration a1, and the second lasting five seconds with average acceleration a2. The final velocity after fifteen seconds is +24.5 m/s, and the ratio of the accelerations is a1/a2 = 1.67. The calculated velocity at the end of the first ten seconds is +26 m/s. The discussion emphasizes using initial and final velocities to determine average accelerations through simultaneous equations.
Cursed
Messages
38
Reaction score
0

Homework Statement


A car is traveling along a straight road at a velocity of +31.0 m/s when its engine cuts out. For the next ten seconds, the car slows down, and its average acceleration is a1[/size]. For the next five seconds, the car slows down further, and its average acceleration is a2[/size]. The velocity at the end of the fifteen-second period is +24.5 m/s. The ratio of the average acceleration values is a1[/size]/a2[/size] = 1.67. Find the velocity of the car at the end of the initial ten-second interval.

Homework Equations


VF = V0 + at

VF = Final velocity
V0 = Initial velocity
a = acceleration
t = time

The Attempt at a Solution



The answer is +26 m/s, but I don't know how to get it...

24.5 = 31.0 + a2
(15)

a2
= -13/30 = -4.333...
a1
= -3.8534

VF = 31.0 + (-3.8534)(10)
VF = -7.534
 
Last edited:
Physics news on Phys.org
Ok, do you know that you can find the average acceleration just by doing simple operations with the inidial velocity and the final velocity?And with that you can find the values of a1 and a2 through use of simultaneous equations. You should be able to solve from here.
 
Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Thread 'A bead-mass oscillatory system problem'
I can't figure out how to find the velocity of the particle at 37 degrees. Basically the bead moves with velocity towards right let's call it v1. The particle moves with some velocity v2. In frame of the bead, the particle is performing circular motion. So v of particle wrt bead would be perpendicular to the string. But how would I find the velocity of particle in ground frame? I tried using vectors to figure it out and the angle is coming out to be extremely long. One equation is by work...
Back
Top