Comparing 460VAC/230VAC & 440VAC/220VAC Transformer Voltages

  • Thread starter Thread starter Stanley_Smith
  • Start date Start date
  • Tags Tags
    Transformer Voltage
AI Thread Summary
The discussion centers on the comparison between 460VAC/230VAC and 440VAC/220VAC transformers, highlighting that both can output the same voltage based on the actual input voltage. The nominal voltage standards vary by region, with many European countries transitioning to the 460/230 standard, while the US typically uses 480/240/120. Although the transformers may differ in kVa ratings, their voltage ratios are essentially equivalent. Therefore, the two transformer types can be considered functionally similar for most applications. Understanding regional voltage standards is crucial for ensuring compatibility and performance.
Stanley_Smith
Messages
16
Reaction score
0
I'm using a 460VAC/230VAC single phase transformer. My customer insists wanting to have 440VAC/220VAC one instead. The ratio between the two transformers are the same. How different are the two? Are they essentially the same ?

Thank you,
 
Engineering news on Phys.org
Both will output the same voltage, which will be determined by the actual voltage input. I'm guessing you are in Europe? The nomial voltage can be either depending on the country (apparently, most are switching to the 460/230 standard). In the US, nominal is 480/240/120.

The two transformers may have different kVa ratings due to the voltage difference... but if you ratio them to the voltage, I bet you'll find they are exactly the same.
 
Thread 'Weird near-field phenomenon I get in my EM simulation'

Thread 'Weird near-field phenomenon I get in my EM simulation'

I recently made a basic simulation of wire antennas and I am not sure if the near field in my simulation is modeled correctly. One of the things that worry me is the fact that sometimes I see in my simulation "movements" in the near field that seems to be faster than the speed of wave propagation I defined (the speed of light in the simulation). Specifically I see "nodes" of low amplitude in the E field that are quickly "emitted" from the antenna and then slow down as they approach the far...
View full post »

Thread 'EMF (Electromagnetic Field) & EHS (Electromagnetic Hyper Sensitivity)'

Hello dear reader, a brief introduction: Some 4 years ago someone started developing health related issues, apparently due to exposure to RF & ELF related frequencies and/or fields (Magnetic). This is currently becoming known as EHS. (Electromagnetic hypersensitivity is a claimed sensitivity to electromagnetic fields, to which adverse symptoms are attributed.) She experiences a deep burning sensation throughout her entire body, leaving her in pain and exhausted after a pulse has occurred...
View full post »

Similar threads

Amperage used versus amperage billed
Replies
1
Views
1K
Modifying generator windings to convert output from 220V to 55V.
Replies
8
Views
2K
Question about generating split phase power
Replies
6
Views
2K
Start capacitors on 2 phase equipment
Replies
3
Views
1K
How to Make a 24V Transformer Output 24V?
Replies
18
Views
4K
Metering a Single Phase 208 VAC Circuit
2
Replies
77
Views
7K
MMF diagrams of transformer construction options
Replies
9
Views
2K
Partial Discharge Analysis for Transformer Insulation Testing
Replies
1
Views
1K
AC generator output voltage to grid question
Replies
4
Views
2K
Transformer without separate primary and secondary windings....
Replies
14
Views
3K

Hot Threads

Recent Insights

Back
Top