Conceptual center of mass question - No calculations

AI Thread Summary
A larger angle for a ladder against a smooth wall is necessary to enhance stability due to the balance of forces and moments acting on it. Increasing the angle reduces the horizontal component of the force exerted by the ladder on the wall, which helps prevent slipping. The center of mass becomes higher with a person on the ladder, but a steeper angle can counteract this by providing a stronger base of support. Summing the moments about the base shows that torque is affected by the angle, influencing stability. The R.D. Werner Ladder Co. suggests a 75-degree angle for optimal safety and stability.
crafty2288
Messages
13
Reaction score
0

Homework Statement


In using a ladder where the wall is smooth but the floor has a coefficient Us, why is it necessary to make the angle large?


Homework Equations


p11-78alt.gif



The Attempt at a Solution



I'm a little confused by this, because I would think that you would want to make the angle smaller and have the center of mass be lower. What is the benefit of the ladder being more vertical?
 

Attachments

  • p11-78alt.gif
    p11-78alt.gif
    14 KB · Views: 446
Physics news on Phys.org
Is the question specifically asking why to make the angle larger? Because normally, your reasoning would be correct.
 
Here is the exact problem as my professor wrote it. i didn't post it before, because frankly... His handwriting is impossible to decipher. I am just confused because the mass of the person makes the center of mass EVEN higher. I see no reason why increasing the angle is beneficial.

9308e978367172.gif
 
Well it seems that if you sum the moments about the point where it touches the bottom, the moments will depend on cosθ. But this is assuming the the center of mass of the person is directly on the ladder.


EDIT: I forgot about the other normal force. To be honest, I really don't see how increasing that angle will make it more stable.
 
Try looking at the torque produced by the mg-force and the normal force from the wall with respect to the point of contact on the ground. What happens if the angle increases/decreases?

The R.D. Werner Ladder Co. recommends that its ladders be used at an angle of 75 degrees.
 
Last edited:
Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...
Back
Top