Connect the two amplifiers to give me 1100 watts

  • Thread starter Thread starter N0 Name
  • Start date Start date
  • Tags Tags
    Amplifiers Watts
AI Thread Summary
Connecting two amplifiers to a single speaker is not advisable, as it can damage the equipment, particularly the pre-amps. While the goal is to achieve a combined output of 1100 watts, doing so without proper equipment can lead to issues. A mixer or specialized device may be required to safely combine the outputs of both amplifiers. It's important to research and utilize the correct setup to avoid damaging the amplifiers or speakers. Seeking professional advice or using dedicated audio equipment is recommended for optimal results.
N0 Name
Messages
2
Reaction score
0
hi

can i connect two amplifires to one speaker.
i have sony amplifire 500 watts and JBL amplifire 600 watts.
and two speakers 800 watts.

Q
i want to connect the two amplifires to give me 1100 watts to look like one amplifire.

thanx
 
Engineering news on Phys.org
I know that when I accidentally fed both channels of a stereo into the same speaker, it blew one of the pre-amps... so I wouldn't try it with two amps. There might be some sort of mixer available, though.
 
My friend saw it on TV but he dosen't remember how did they connect it

will thanks for replay
 

Thread 'Underwater piezoelectric sensor array receive sensitivity'

Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
View full post »

Thread 'What happens if shielded cable has short to the shield?'

While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
View full post »

Thread 'Question about bonding ground and neutral'

I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
View full post »

Similar threads

Power Amplifier and Exciter, Impedance / Power
Replies
7
Views
2K
Maximizing Power Output: Amplifiers in Bridge Mode
Replies
4
Views
3K
Combining 2 grid connections ac to one
Replies
2
Views
1K
How Can I Build a Basic Transistor Amplifier for My Phone's Speaker?
Replies
5
Views
2K
What is the difference between lumen efficiency and efficacy in lighting?
Replies
4
Views
2K
If I connect two 4700 uf capacitors in parallel with my 8.3A battery
Replies
16
Views
2K
Hooking Up Two Inverter Generators, Its Done, Just Wires?
Replies
2
Views
28K
Can I Use 500W Voltage Converter on 110-127V Appliance?
Replies
1
Views
1K
Can someone resolve an argument over audio amplifier and wiring theory?
Replies
4
Views
2K
Voltage transformers and magnetic field leakage
Replies
23
Views
5K

Hot Threads

Recent Insights

Back
Top