Convex Lens and Light Refraction

AI Thread Summary
Light passing through the center of a convex lens will continue straight without bending. If light rays enter beyond the focal point, they will converge towards the center, creating an inverted image. When light sources are closer than the focal point, a virtual image is formed, appearing between the lens and the viewer. The outcome of light refraction through a convex lens is highly dependent on the positioning of the light source relative to the focal point. For further clarification, consulting resources like the Wikipedia page on lenses can provide additional diagrams and information.
pmmiller14
Messages
10
Reaction score
0
Hi all,

if light was to go straight through a convex lens would it come out straight or inverted to a point? also if light was to go through the same lens but goes through going inwards how would the light be refracted?
 
Last edited:
Science news on Phys.org
I think we need a bit more information, first. So, if a ray of light enters the very center of a lens, it will pass straight through, unbent. If the source point is beyond the focal point of the lens, the light rays will tend to bend toward the center of the lens, and if it the source point is closer than the focus, you'll get what's called a "virtual image," wherein it appears that the source is between the lens and the viewer (think magnifying glass).

To get any more specific, I think you'll need to constrain the setup a bit more. Take a look at the Wikipedia page on lenses and see if we can work forward from that.
 
apologies on the description. what it was meant to say is that if rays of light are straight before they go through a convex lens would it come out straight or will the light be refracted and bent to make a point? the other one is if the light was already bent to create a point would it come out straight or the same?
 
Right, it still depends on the positioning of the light. Check out the Wikipedia page on lenses, all the diagrams you're looking for can be found there.
 
ok thank you for your help :)
 
Thread 'A quartet of epi-illumination methods'
Well, it took almost 20 years (!!!), but I finally obtained a set of epi-phase microscope objectives (Zeiss). The principles of epi-phase contrast is nearly identical to transillumination phase contrast, but the phase ring is a 1/8 wave retarder rather than a 1/4 wave retarder (because with epi-illumination, the light passes through the ring twice). This method was popular only for a very short period of time before epi-DIC (differential interference contrast) became widely available. So...
I am currently undertaking a research internship where I am modelling the heating of silicon wafers with a 515 nm femtosecond laser. In order to increase the absorption of the laser into the oxide layer on top of the wafer it was suggested we use gold nanoparticles. I was tasked with modelling the optical properties of a 5nm gold nanoparticle, in particular the absorption cross section, using COMSOL Multiphysics. My model seems to be getting correct values for the absorption coefficient and...
Back
Top