Creating Static Electricity: Pocket Held Devices

AI Thread Summary
Creating a pocket-held device for generating static electricity involves using high-voltage generators, which can produce up to 20kV. These devices can be built or purchased, but effective use requires insulation from the ground, such as wearing special shoes. Ionizing air guns, while effective for industrial applications, are expensive and provide only temporary effects on static charge. The discussion highlights the challenges of maintaining a static charge on the body and the practicality of such devices. Overall, the feasibility of a personal static electricity generator remains complex and requires careful consideration of insulation and safety.
designstop
Messages
2
Reaction score
0
Hi. not being expert in this field, I have a question about static electricity. I have seen balloons stuck to hair by rubbing them. If I wanted to create a (pocket held) electronic devise to create that charge on the body, so a balloon can be attached without rubbing, how would it be done. And similarly, can a hand held or pocket held make a charge , to prevent a balloon being stuck onto body, and how would such device be made?.

Thanks

DS
 
Engineering news on Phys.org
While I don't know how effective it would be, there are industrial static removers used for cleaning. They're called ionizing air guns. They shoot out a bunch of ionized air at the target which is supposed to help remove charge and electrically attracted debris.

They're quite expensive and are often used in clean rooms to prevent build up of charge on sensitive machinery. Any effect, if present, on the balloon would be only temporary anyway.
 
fedaykin said:
While I don't know how effective it would be, there are industrial static removers used for cleaning. They're called ionizing air guns. They shoot out a bunch of ionized air at the target which is supposed to help remove charge and electrically attracted debris.

They're quite expensive and are often used in clean rooms to prevent build up of charge on sensitive machinery. Any effect, if present, on the balloon would be only temporary anyway.

Thanks for the reply, Fed. I am actually looking for a electronic device to do this. Something that one could attach to their body, and it will either repel or attract items. Thanks
 
Do you want to charge up your whole body?
There are small battery powered high voltage generators that can produce up to 20kV.
You can either build one or buy one. I once saw one for 20$ on ebay.
But you can only charge yourself when you are insulated from ground. So you either have to stay at a place where the ground is insulating, which can be difficult, or wear special shoes with insulating soles.
 
If you want a very dramatic effect, a Van de Graaff would be great.
 
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...

Similar threads

Back
Top