Did Police Make the Right Call in Speeding Arrest Based on Skid Mark Length?

  • Thread starter Thread starter courtrigrad
  • Start date Start date
AI Thread Summary
The discussion centers on whether a driver was speeding based on the length of skid marks measuring 19.2 feet. Initial calculations suggested the driver was traveling at 35 ft/sec, indicating speeding. However, further analysis revealed that when converted to miles per hour, the driver's speed was actually 23.86 mph, which is below the 30 mph limit. The police's assumption regarding maximum deceleration was challenged, leading to the conclusion that the driver was not speeding. Ultimately, the arrest for speeding was deemed incorrect.
courtrigrad
Messages
1,236
Reaction score
2
The question is whether a driver is exceeding a 30 miles/hr speed limit before he makes an emergency stop. The length of the skid marks on the road is 19.2 feet. The police assumed that the maximum deacceleration of the car would not exceed the acceleration of a freely falling body and arrested the driver for speeding. Was this correct to do?

So the acceleration of a freely falling body is a = -32 \frac{ft}{sec^{2}}. So v_{x}^{2} = v_{x}_{0}^{2} + 2a_{x}(x-x_{0}}). Since v_{x} = 0, 0 = v_{x}_{0}^{2} - 64(19.2). So v_{x}_{0}^{2} = 1228.8 and v_{x}_{0} = 35. So he was speeding. Is this correct?

Thanks
 
Physics news on Phys.org
Be careful with your units! You used 32 ft/s^2 for the acceleration and 19.2 feet for the distance. What are the units of v? :)
 
v_{x}_{0} = 35 \frac{ft}{sec}. Is this correct?

Thanks
 
So, was the driver speeding?
 
no he wasnt. he was only traveling 23.86 miles per hour. I converted ft/sec to miles/hour.
 
TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...
Thread 'Variable mass system : water sprayed into a moving container'
Starting with the mass considerations #m(t)# is mass of water #M_{c}# mass of container and #M(t)# mass of total system $$M(t) = M_{C} + m(t)$$ $$\Rightarrow \frac{dM(t)}{dt} = \frac{dm(t)}{dt}$$ $$P_i = Mv + u \, dm$$ $$P_f = (M + dm)(v + dv)$$ $$\Delta P = M \, dv + (v - u) \, dm$$ $$F = \frac{dP}{dt} = M \frac{dv}{dt} + (v - u) \frac{dm}{dt}$$ $$F = u \frac{dm}{dt} = \rho A u^2$$ from conservation of momentum , the cannon recoils with the same force which it applies. $$\quad \frac{dm}{dt}...
Back
Top