What Is the pH of a Solution with Double Dissociation of Ascorbic Acid?

  • Thread starter Thread starter relativitydude
  • Start date Start date
AI Thread Summary
The discussion revolves around calculating the pH of a solution with a given concentration of ascorbic acid and its dissociation products. The user initially sets up the dissociation equations but encounters issues with imaginary values in their calculations. They express confusion about the correct setup for the second dissociation step, particularly regarding the concentrations of the conjugate anion and the acid. The user’s chemistry teacher indicated that the products should not be squared in the calculations. Overall, the thread highlights common challenges in understanding acid dissociation and equilibrium calculations.
relativitydude
Messages
70
Reaction score
0
Hello again,

Yes, it's me with another disassociation problem.

If you have .0213M of ascorbic acid, what is the pH of a solution containing the second disassociated form?

Ok,

HC6H7O6 <--> H + C6H7O6

8.0e-5 = x^2 / (.0213 - x)
x = 1.265e-3M

C6H7O6 <---> H + C6H6O6
.02M - x (1.265-3 + x) (1.265-3 + x)

so,

1.6e-12 = (1.265e-3+x)^2/(.02-x)

Now I apparently set up the second part wrong as I am getting imaginary molarities and pHs. My chemistry teacher said I was not supose to square the rpoducts like that.

I do not understand why
 
Chemistry news on Phys.org
C6H7O6 <---> H + C6H6O6
.02M - x (1.265-3 + x) (1.265-3 + x)

The initial concentration of the conjugate anion is 0. Also the initial concentration of the acid for the second Ka should be the same as the hydronium concentration.
 
I want to test a humidity sensor with one or more saturated salt solutions. The table salt that I have on hand contains one of two anticaking agents, calcium silicate or sodium aluminosilicate. Will the presence of either of these additives (or iodine for that matter) significantly affect the equilibrium humidity? I searched and all the how-to-do-it guides did not address this question. One research paper I found reported that at 1.5% w/w calcium silicate increased the deliquescent point by...
I'm trying to find a cheap DIY method to etch holes of various shapes through 0.3mm Aluminium sheet using 5-10% Sodium Hydroxide. The idea is to apply a resist to the Aluminium then selectively ablate it off using a diode laser cutter and then dissolve away the Aluminium using Sodium Hydroxide. By cheap I mean resists costing say £20 in small quantities. The Internet has suggested various resists to try including... Enamel paint (only survived seconds in the NaOH!) Acrylic paint (only...

Similar threads

Back
Top