How Much Torque Does an Electric Motor Develop at 3000 RPM?

AI Thread Summary
An electric motor consumes 12.0 KJ of electrical energy in one minute, with one-third lost to heat, leaving 8.0 KJ for output. The power output is calculated as 480,000 W, but the initial calculation of power was incorrect due to a misunderstanding of the relationship between energy and power. The angular speed is converted to 314.2 rad/s for torque calculation. The correct torque is derived from the formula T = power / angular speed, leading to a torque of approximately 1.37 kN·m. The discussion highlights the importance of accurately applying physics principles in calculations.
irun4edmund
Messages
14
Reaction score
0

Homework Statement


An electric motor consumes 12.0 KJ of electrical energy in 1.00 min. If one-third of this energy goes into heat and other forms of internal energy of the motor, with the rest going to the motor output, how much torque will this engine develop if you run it at 3000 rpm?


Homework Equations





The Attempt at a Solution


Since one third of the energy is converted to heat only 2/3 contribute to torque or 8.0 KJ

I get P = 8KJ * 60s = 480 * 10^3 W

converting angular speed from rpm to rad/s i get (3000 * 2 pi) / 60s = 314.2 rad/s

since torque = power / angular speed:
T = (480 * 10^3) / 314.2 = 1.37 *10^3

but I am not getting the right answer. any help would be greatly apreciated.
 
Last edited:
Physics news on Phys.org
irun4edmund said:

Homework Statement


An electric motor consumes 12.0 KJ of electrical energy in 1.00 min. If one-third of this energy goes into heat and other forms of internal energy of the motor, with the rest going to the motor output, how much torque will this engine develop if you run it at 3000 rpm?


Homework Equations





The Attempt at a Solution


Since one third of the energy is converted to heat only 2/3 contribute to torque or 8.0 KJ

I get P = 8KJ * 60s = 480 * 10^3 W

(I accidentally deleted my last reply.)

I believe here is an error. A Watt is a Joule/second, so power is not the energy multiplied by the time.
 
yup. thanks a lot. Just a silly mistake on my part. Thats what i get for trying to do phyics at 1 am.
 
Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Trying to understand the logic behind adding vectors with an angle between them'
My initial calculation was to subtract V1 from V2 to show that from the perspective of the second aircraft the first one is -300km/h. So i checked with ChatGPT and it said I cant just subtract them because I have an angle between them. So I dont understand the reasoning of it. Like why should a velocity be dependent on an angle? I was thinking about how it would look like if the planes where parallel to each other, and then how it look like if one is turning away and I dont see it. Since...
Back
Top