Electronic Door Control Design Ideas

AI Thread Summary
The discussion centers on designing an electronic door control system for a project class. The user seeks advice on devices to electronically open and close a miniature door using momentary pushbuttons. Suggestions include exploring automatic door mechanisms found in hospitals and supermarkets for inspiration. A worm drive and motor are recommended as a feasible solution if speed is not a critical factor. The conversation emphasizes practical applications and potential mechanisms for the project.
RegardedBody
Messages
1
Reaction score
0
Hi guys, I'm new to this forum, I'm in my final semester studying control systems and need to design something for my project class.I was thinking of building a miniature door frame with a door that opens and closes electronically while controlled by momentary on and off pushbuttons. But what kinda of device can I use to electronically open/close the door?

Some kind of piston device?

Any ideas are appreciated! :)
 
Engineering news on Phys.org
RegardedBody said:
Hi guys, I'm new to this forum, I'm in my final semester studying control systems and need to design something for my project class.


I was thinking of building a miniature door frame with a door that opens and closes electronically while controlled by momentary on and off pushbuttons. But what kinda of device can I use to electronically open/close the door?

Some kind of piston device?

Any ideas are appreciated! :)

Welcome to the PF.

Look at automatic doors at hospitals and even the supermarket. What do they look like they are using?

If speed is not a big issue, you can use a worm drive and motor.
 
Hi all, I have a question. So from the derivation of the Isentropic process relationship PV^gamma = constant, there is a step dW = PdV, which can only be said for quasi-equilibrium (or reversible) processes. As such I believe PV^gamma = constant (and the family of equations) should not be applicable to just adiabatic processes? Ie, it should be applicable only for adiabatic + reversible = isentropic processes? However, I've seen couple of online notes/books, and...
I have an engine that uses a dry sump oiling system. The oil collection pan has three AN fittings to use for scavenging. Two of the fittings are approximately on the same level, the third is about 1/2 to 3/4 inch higher than the other two. The system ran for years with no problem using a three stage pump (one pressure and two scavenge stages). The two scavenge stages were connected at times to any two of the three AN fittings on the tank. Recently I tried an upgrade to a four stage pump...
Back
Top