Energy Conversion in DC Machines | Motors & Generators

AI Thread Summary
Energy conversion in DC machines, whether as motors or generators, involves Lenz's Law, where the current generated opposes the magnetic field, creating a resistive force against the armature's motion. This interaction results in the production of torque when a current-carrying conductor is placed in a magnetic field, demonstrating the principles of electromagnetic induction. Understanding these concepts may require consulting textbooks or resources like Wikipedia for a foundational overview. The discussion emphasizes the complexity of the topic, suggesting that specific questions can facilitate clearer answers. Overall, grasping the mechanics of energy conversion in DC machines is essential for comprehending their operation.
vvkannan
Messages
21
Reaction score
0
How energy conversion takes place in dc machines (motor or generator)
 
Engineering news on Phys.org
You should grab a textbook for an explanation. Wikipedia probably has something on this as well. It's too much to explain how it works in one post.
 
ok i better ask specific questions so that it wud be easier to answer.first of all in generators how and wat force is produced,that resists the motion of armature being moved by a prime mover.
 
A current is produced in the generator which would oppose the magnetic field (usually of permanent magnets). This is Lenz's Law in action. And I second taking a look at the Wikipedia articles on generators and motors, which will give you a high-level introduction to this topic. After that, perhaps an introductory electromagnetics textbook? You're asking a lot with this question.
 
energy coonversion is taking place in dc machines by the action of lenz law.current passes thru the coil which felts under magnetic field and turns to induction principle.ie: curren carrying conductor in a magnetic field effects a force which inturns into a torque.
 
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
Back
Top