What are the best books for designing RC and LC oscillators with op-amps?

  • Thread starter Thread starter eng.mustafaS
  • Start date Start date
  • Tags Tags
    Books Oscillators
AI Thread Summary
The discussion focuses on finding recommended books for designing RC and LC oscillators using op-amps. A notable recommendation is "Microelectronic Circuits" by Sedra and Smith, specifically the 5th or 6th edition, which provides a comprehensive overview of signal generators and waveform-shaping circuits. Participants express gratitude for the suggestions and emphasize the book's insights despite its lack of extensive detail. The conversation highlights the importance of foundational knowledge in oscillator design. Overall, "Microelectronic Circuits" is presented as a valuable resource for those interested in this topic.
eng.mustafaS
Messages
9
Reaction score
0
i want some books about oscillators

RC oscillator by op-amp
LC oscillator by op-amp

design it this kind of OC


and thank you
 
Last edited by a moderator:
Engineering news on Phys.org
I would recommend Microelectronic Circuits 5th (or 6th) edition by Sedra/Smith.
Well, it is not too detailed, but it gives the whole picture with a lot of good insights regarding signal generators and waveform-shaping circuits.
 
Su3liminal said:
I would recommend Microelectronic Circuits 5th (or 6th) edition by Sedra/Smith.
Well, it is not too detailed, but it gives the whole picture with a lot of good insights regarding signal generators and waveform-shaping circuits.

thank you brother
 

Thread 'How might electronics be different if AC voltage was 72V at 45 Hz?'

Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
View full post »

Thread 'What happens if shielded cable has a short to the shield?'

While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
View full post »

Thread 'Why does the amperage go real high if there is a low voltage short?'

I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
View full post »

Similar threads

Op-amp Oscillator Circuit Design (10-50 MHz)
Replies
6
Views
3K
Purely passive RC Phase Shift Oscillator?
Replies
27
Views
3K
What's wrong in my LTspice simulation of an Op-Amp integrator circuit?
Replies
9
Views
6K
Op-amp compensation of cascade fudges audio signal oddly
Replies
3
Views
2K
RC Phase Shift Oscillator not Oscillating
Replies
41
Views
7K
DC input random offset voltage for diff. amplifier with current-mirror load
Replies
2
Views
1K
How does LC phase shift oscillator work?
Replies
1
Views
4K
RC Oscillator Circuit Adjusting Frequency
Replies
10
Views
4K
Amplifier for piezoelectric sensor, OP Amp circuit
Replies
6
Views
5K
Heavy Amplifier Circuit Oscillation Happened
Replies
3
Views
2K

Hot Threads

Recent Insights

Back
Top