How Does Wire Length Affect Voltage in an Electrical Circuit?

AI Thread Summary
Wire length affects voltage in an electrical circuit, as observed in an investigation where voltage readings increased slightly (about 0.1 V) with longer wire lengths (10-100 cm). This phenomenon is attributed to internal resistance and energy loss due to higher resistance in the circuit. If the power supply has internal resistance, it impacts voltmeter readings, especially as current changes. The relationship between voltage and resistance becomes crucial when considering a power pack with finite source resistance. Understanding these dynamics is essential for accurate circuit analysis.
polekitten
Messages
5
Reaction score
0

Homework Statement


We conducted an investigation into wire length, current and resistance but kept track of the voltage rather than relying on the power pack setting. We noticed the voltmeter (measuring across the power pack) reading increased as the length of the wire increased though by only about 0.1 V from 10-100 cm lengths.

Homework Equations

The Attempt at a Solution


Is this something to do with internal resistance and energy being lost due to the higher resistance?
 
Physics news on Phys.org
polekitten said:

Homework Statement


We conducted an investigation into wire length, current and resistance but kept track of the voltage rather than relying on the power pack setting. We noticed the voltmeter (measuring across the power pack) reading increased as the length of the wire increased though by only about 0.1 V from 10-100 cm lengths.

Homework Equations

The Attempt at a Solution


Is this something to do with internal resistance and energy being lost due to the higher resistance?
You have suggested internal resistance. What would happen to our voltmeter readings during the experiment if the power supply had a small internal resistance, such as 1 Ohm? Say the current changes from 0.1 amp to 1 amp as the wire is shortened.
 
You have not defined the power pack electrically. The easiest assumption would be that is is a source of constant current, in which case the relation between V and R should be obvious.

If the power pack has finite (as opposed to infinite) source resistance then that resistance has to be included in your computations of R, given V.
 
TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...
Thread 'Variable mass system : water sprayed into a moving container'
Starting with the mass considerations #m(t)# is mass of water #M_{c}# mass of container and #M(t)# mass of total system $$M(t) = M_{C} + m(t)$$ $$\Rightarrow \frac{dM(t)}{dt} = \frac{dm(t)}{dt}$$ $$P_i = Mv + u \, dm$$ $$P_f = (M + dm)(v + dv)$$ $$\Delta P = M \, dv + (v - u) \, dm$$ $$F = \frac{dP}{dt} = M \frac{dv}{dt} + (v - u) \frac{dm}{dt}$$ $$F = u \frac{dm}{dt} = \rho A u^2$$ from conservation of momentum , the cannon recoils with the same force which it applies. $$\quad \frac{dm}{dt}...
Back
Top