Fin & Tube Radiator: Complete Theory Explained

  • Thread starter Thread starter distinctions
  • Start date Start date
  • Tags Tags
    Radiator Tube
AI Thread Summary
The discussion centers on the need for a comprehensive understanding of fin and tube radiators, emphasizing the importance of the heat transfer process between the hot and cold sides. Participants highlight that providing detailed questions will yield more thorough answers. One contributor notes a potential overheating issue with a car running at 240 degrees Fahrenheit, suggesting a connection to the radiator's performance. The conversation underscores the necessity of clarity in inquiries to facilitate better assistance. Overall, a detailed exploration of radiator theory is sought to address specific concerns.
distinctions
Messages
4
Reaction score
0
i need complete theory of tht pleasez help me
 
Engineering news on Phys.org
You have a hot side and a cold side, heat goes from one to the other.

A more complete question will earn you a more complete answer.
 
no kidding?? maybe that's why the car is running 240 deg F...
 
can u people help me in theory in detail
 
If you want a detailed answer, ask a detailed question. You really didn't read my first post did you?
 

Thread 'Race car suspension Class'

Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
View full post »

Thread 'Cantilever help'

I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
View full post »
Thread 'What's the most likely cause for this carbon seal crack?'

Thread 'What's the most likely cause for this carbon seal crack?'

We have a molded carbon graphite seal that is used in an inline axial piston, variable displacement hydraulic pump. One of our customers reported that, when using the “A” parts in the past, they only needed to replace them due to normal wear. However, after switching to our parts, the replacement cycle seems to be much shorter due to “broken” or “cracked” failures. This issue was identified after hydraulic fluid leakage was observed. According to their records, the same problem has occurred...
View full post »

Similar threads

Water cooler radiator with unusual air flow direction
Replies
3
Views
1K
Do Dual Fans Increase Radiator Efficiency More Than a Single Larger Fan?
Replies
6
Views
4K
Design of a shell and tube heat exchanger
Replies
1
Views
1K
Automotive Air speed in car radiator -- Heat Exchange calculations
Replies
4
Views
5K
Adjusting the pressure of helium flow to account for smaller tube
Replies
6
Views
1K
How to determine air velocity in open ended tube?
Replies
9
Views
2K
Advice for building a Hilsch Vortex tube
Replies
6
Views
2K
Cleaning of the finned tubes on gas cooler without disassembling
Replies
7
Views
2K
What is the Cooling Time for Steel Tubes with Ambient Nitrogen Gas Flow?
Replies
7
Views
3K
Measuring the water volume in a small tank with a manometer
Replies
26
Views
2K

Hot Threads

Recent Insights

Back
Top