Force exerted on U-shaped pipe by steady air-flow help please

ds7202
Messages
2
Reaction score
0
Force exerted on U-shaped pipe by steady air-flow... help please! :)

Hello! I have attempted this problem, and my result makes sense in my twisted mind. However, it seems like it came too easy!

Homework Statement



Consider a length of pipe bent into a U-shape. The inside diameter of the pipe is 0.2m. Air enters one leg of the pipe at a mean velocity of 10 m/s and exits the other leg at the same magnitude of velocity, but moving in the opposite direction. The pressure of the flow at the inlet and exit is the ambient pressure of the surroundings. Calculate the magnitude and direction of the force exerted on the pipe by the airflow. The air density is 1.23 kg/m^3.

Homework Equations



I attempted this problem using the steady-flow momentum equation, \sum\vec{F} = \int\rho\vec{v}(\vec{v}\cdot\vec{n})dA

The Attempt at a Solution



My attempt at the solution can be viewed here:
http://i.imgur.com/SHItH.jpg


Pleeeeease help! Thanks! :D
 
Physics news on Phys.org


I looked through your calculation, they don't seem wrong, but I didn't study that equation so I don't know if it is correct to use it.

However, I think that a pipe like the one in the problem would move in some way, because it seems very close to the problem of a ball rebounding on a wall: the initial and final condition of the ball are the same, except from the velocity that is the opposite. In these kind of problem, since the velocity varies, you have some forces acting (Newton's second law).
I'd use this way of reasoning - but I'm not sure it is correct. In addition, to perform my calculation I need the length of the pipe, and you did not provided it. So maybe my way is not the correct one. Nevertheless, I think that it must be considered some kind of non-zero force, because the air actually changes its velocity!

Hope you understand (my English is not perfect :D:D:D )
 


I realize what I did wrong. I used the velocity's normal vector instead of the control surface's normal vector, haha
 
To solve this, I first used the units to work out that a= m* a/m, i.e. t=z/λ. This would allow you to determine the time duration within an interval section by section and then add this to the previous ones to obtain the age of the respective layer. However, this would require a constant thickness per year for each interval. However, since this is most likely not the case, my next consideration was that the age must be the integral of a 1/λ(z) function, which I cannot model.
Back
Top