Frequency Response Function analysis in ANSYS

AI Thread Summary
Frequency Response Function (FRF) analysis in ANSYS is being sought by a user who is using version 10.0 of the software. The user requests assistance in performing this analysis. Other participants inquire about the user's familiarity with ANSYS and offer to help with simple analyses. The discussion emphasizes the need for guidance on FRF analysis techniques within the specified version of ANSYS. Assistance is being actively sought to navigate this specific analysis process.
rajasardar
Messages
3
Reaction score
0
Hello
Can anybody please help me to perform a Frequency Response Function analysis in ANSYS
many thanks in advance
 
Engineering news on Phys.org
rajasardar said:
Hello
Can anybody please help me to perform a Frequency Response Function analysis in ANSYS
many thanks in advance

Do you know how to use ANSYS? What version do you have?
 
I can perform the simple analysis
and using ANSYS 10.0
could you please help me
 

Thread 'Race car suspension Class'

Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
View full post »

Thread 'Cantilever help'

I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
View full post »
Thread 'What's the most likely cause for this carbon seal crack?'

Thread 'What's the most likely cause for this carbon seal crack?'

We have a molded carbon graphite seal that is used in an inline axial piston, variable displacement hydraulic pump. One of our customers reported that, when using the “A” parts in the past, they only needed to replace them due to normal wear. However, after switching to our parts, the replacement cycle seems to be much shorter due to “broken” or “cracked” failures. This issue was identified after hydraulic fluid leakage was observed. According to their records, the same problem has occurred...
View full post »

Similar threads

Tuned mass damper does not reduce the amplitude of vibration?
Replies
4
Views
1K
Modal mass and kinetic energy in FEM modal analysis
Replies
3
Views
3K
Convergence problems in ANSYS batch mode but not in GUI
Replies
6
Views
5K
Importing material properties in ANSYS ACP
Replies
6
Views
3K
Why Does My Axial Fan Wobble at Certain Frequencies?
Replies
1
Views
2K
Automotive Amplitude based frequency response simulation in Abaqus
Replies
3
Views
2K
Storage vessel stress analysis using ansys
Replies
2
Views
1K
Meshing & connection issues for a beam/line solid
Replies
1
Views
2K
Ansys Solution as Input Geometry
Replies
1
Views
1K
Confidence in FEA stress values?
Replies
9
Views
3K

Hot Threads

Recent Insights

Back
Top