Getting graph of v(t) on oscilloscope?

AI Thread Summary
To display a v(t) graph on a Tektronix TDS 210 oscilloscope, ensure the voltage input is under ten volts AC to avoid damage. Properly trigger the signal either internally or externally and adjust the time base according to the frequency of the waveform; for a 100 MHz signal, set the time resolution to 1 to 10 nanoseconds per sweep. If the time base is set incorrectly, the waveform may not be visible. Tutorials from Tektronix can provide additional guidance on using oscilloscopes effectively. Accessing the manual can also be beneficial for specific instructions.
seto6
Messages
248
Reaction score
0
how do i display a v(t) graph of a oscilloscope.

i don't have a manual for it.
 
Physics news on Phys.org
seto6 said:
how do i display a v(t) graph of a oscilloscope.

i don't have a manual for it.

Here are some good primers and tutorials from Tektronix on oscilloscopes:

http://www.tek.com/learning/oscilloscopes/

Which 'scope are you working with?
 
its a Tektronix model TDS 210
 
When you say 'graph', do you mean like a stored image on the scope of a waveform? Like in digital storage scopes? Or do you mean just voltage display? I assume you are looking at some AC waveform, do you know the frequency? There is usually a BNC or two where you input the voltage, usually under ten volts AC, high voltages can damage the scope. Then you have to trigger the signal, either internally or externally and you have to have the right time base dialed in. If you are trying to display a frequency of 100 Mhz, you would need to have the time resolution at somewhere around 1 to 10 nanoseconds per sweep. If you tried to look at 100 mhz and had 1 millisecond dialed in you would just see a band of light with no signal resolved. Hope that helps.

Don, AI3N, Delaware Lehigh Amateur Radio Club, Allentown/Bethleham Pa.
 
Thread 'Is there a white hole inside every black hole?'

Thread 'Is there a white hole inside every black hole?'

This is what I am thinking. How much feasible is it? There is a white hole inside every black hole The white hole spits mass/energy out continuously The mass/energy that is spit out of a white hole drops back into it eventually. This is because of extreme space time curvature around the white hole Ironically this extreme space time curvature of the space around a white hole is caused by the huge mass/energy packed in the white hole Because of continuously spitting mass/energy which keeps...
View full post »

Thread 'Is Gravity an entropic property like Surface Tension'

Why do two separately floating objects in a liquid "attract" each other ?? What if gravity is an emergent property like surface tension ? What if they both are essentially trying to *minimize disorder at the interfaces — where non-aligned polarized particles are forced to mix with each other* What if gravity is an emergent property that is trying to optimize the entropy emerging out of spin aligned quantum bits
View full post »

Similar threads

Area under v vs t sinusoidal trace
Replies
2
Views
1K
Find maximum current in a coil using oscilloscopes and Faraday's Law?
Replies
5
Views
3K
Tektronix 2465A change rear signal output
Replies
7
Views
1K
FRR Measurement in Digital Oscilloscope
Replies
3
Views
2K
B Rubber band force-extension graph
Replies
6
Views
1K
Digital oscilloscope for high school use
Replies
41
Views
7K
B What Is the Physical Significance of Logarithmic IV Graphs in Diodes?
Replies
3
Views
4K
Converting oscilloscope voltage to laser power
Replies
12
Views
2K
B Why Use a Photodetector in Interferometry?
Replies
13
Views
2K
B How can I approach drawing v-x graphs for projectile motion problems?
Replies
4
Views
3K

Hot Threads

Recent Insights

Back
Top