How can i separate water vapor from biogas

AI Thread Summary
To separate water vapor from biogas, condensation or freezing methods are effective, as water has a lower boiling point than methane and other components. Using a flash tank can help by increasing pressure to condense water vapor, but a standard tank may suffice without the need for specialized equipment. Chemical absorbents like dehydrated magnesium sulfate can remove water, though they are energy-intensive and impractical for large volumes. A demister made from steel wool could potentially purify biogas from water vapor, but its effectiveness would need to be evaluated in the context of the overall system. Proper cooling is essential in any setup to ensure efficient water vapor removal.
Abdallah
Messages
2
Reaction score
0
Hi
I need to know how i can separate the water vapor from biogas
i know that there is separation of H2S and Co2
but what the procedure to remove water vapor from biogas ?
thank you :)
 
Engineering news on Phys.org
Welcome to PF;
[W]hat [is] the procedure to remove water vapor from biogas ?
You condense it out.
 
  • Like
Likes bsheikho
Condensation or freezing is a way to go.
Bio-gas (at least the useful bits of it) is methane maybe some ethane and rarely some propane. All with a boiling point higher than waters freezing point. Or higher pressure to induce condensation. There are chemicals like MgSo4 (dehydrated) that can absorb water although their dehydration is energy consuming and not practical for large quantities.
 
thank you
but can i use flash tank to separate it ??
 
Flash tanks are usually use for evaporating a process that is not necessary. You could use the tank to pump the gas at higher than normal pressure (check the tank specs) which would condense the water. The tank should be cooled not heated.

A normal tank should do, no need for the whole flash tank gear.
 
hi, can you build a demister in PSA system? I am doing my thesis on biogas and was wondering if I can build a demister using a steel wool to purify biogas from water vapour. Do you think it will help?
 
How did you find PF?: Via Google search Hi, I have a vessel I 3D printed to investigate single bubble rise. The vessel has a 4 mm gap separated by acrylic panels. This is essentially my viewing chamber where I can record the bubble motion. The vessel is open to atmosphere. The bubble generation mechanism is composed of a syringe pump and glass capillary tube (Internal Diameter of 0.45 mm). I connect a 1/4” air line hose from the syringe to the capillary The bubble is formed at the tip...
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'
Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
I'd like to create a thread with links to 3-D Printer resources, including printers and software package suggestions. My motivations are selfish, as I have a 3-D printed project that I'm working on, and I'd like to buy a simple printer and use low cost software to make the first prototype. There are some previous threads about 3-D printing like this: https://www.physicsforums.com/threads/are-3d-printers-easy-to-use-yet.917489/ but none that address the overall topic (unless I've missed...
Back
Top