How do you make a circuit board work ?

AI Thread Summary
To make a circuit board work for a robot, it's essential to understand the specific components needed, such as microprocessors and signal lines. Clarification on whether the goal is to build a computer from scratch or use existing parts is necessary. Identifying the contact points for connecting wires is crucial for functionality. The discussion suggests that it may be more cost-effective to purchase a pre-built desktop rather than assembling one from components. Understanding the project requirements and connections is key to successfully operating the circuit board.
janemba
Messages
39
Reaction score
0
i wanted to make a robot and have a circuit board of a desktop and the circuit board of the massively mini media player from tiger electronics,and i wanted to know how you can make the circuit board work and what can tell if it work to ? help would be appreciated
 
Last edited:
Engineering news on Phys.org
I'm not understanding the question. What "desktop"? You mean a computer to run a robot? You want to make a computer from scratch? Clarify, please...
 
yes desktop computer and by scratch
 
it would be cheaper to just buy a desktop. check the de11 outlet. You have to know what you want to do, what you need and work it out from there. Microprocessor, signal/data lines etc
 
yea but how can you make a circuit board work and where are the contact points of making it work in other words where to connect the wires ?
 

Thread '3-terminal device external modeling'

Very basic question. Consider a 3-terminal device with terminals say A,B,C. Kirchhoff Current Law (KCL) and Kirchhoff Voltage Law (KVL) establish two relationships between the 3 currents entering the terminals and the 3 terminal's voltage pairs respectively. So we have 2 equations in 6 unknowns. To proceed further we need two more (independent) equations in order to solve the circuit the 3-terminal device is connected to (basically one treats such a device as an unbalanced two-port...
View full post »

Thread 'Question about the voltage between two charged capacitors'

suppose you have two capacitors with a 0.1 Farad value and 12 VDC rating. label these as A and B. label the terminals of each as 1 and 2. you also have a voltmeter with a 40 volt linear range for DC. you also have a 9 volt DC power supply fed by mains. you charge each capacitor to 9 volts with terminal 1 being - (negative) and terminal 2 being + (positive). you connect the voltmeter to terminal A2 and to terminal B1. does it read any voltage? can - of one capacitor discharge + of the...
View full post »

Similar threads

I found this circuit board in an old toy car. What does it do?
Replies
1
Views
1K
Can We Make PCB Using Paper And Pencil?
Replies
13
Views
1K
Is My Thyristor Gate Driver Circuit Malfunctioning Due to Component Issues?
Replies
12
Views
2K
PVC Induction Heating Coil Design (early thoughts)
2
Replies
51
Views
3K
Solar panel with circuit inside a PC box -Not working
Replies
3
Views
1K
How do pull up and pull down resistors remove electrical noise?
Replies
46
Views
9K
Circuit Board Design: Basics of Designing a PCB
Replies
11
Views
4K
How does AM broadcasting/receiving work + a project for HS students?
Replies
20
Views
1K
How to create an Electric Field?
Replies
5
Views
2K
How Can I Record a Raw Analog Signal with an Arduino Using a Circuit Board?
Replies
5
Views
2K

Hot Threads

Recent Insights

Back
Top