How Is Voltage Induced in a Rotating Coil Within a Magnetic Field?

AI Thread Summary
A circular coil with a radius of 10 cm and 25 turns rotates in a magnetic field of 2.4 T at a frequency of 50 Hz, leading to an induced peak voltage calculation. The peak voltage is determined using the formula V = -N * B * A * ω * sin(θ), resulting in approximately 592.177 V when the coil is perpendicular to the magnetic field. The time-dependence of the induced voltage is expected to resemble a sine wave due to the nature of rotational motion in a magnetic field. The discussion also highlights confusion regarding the application of the right-hand rule and Lenz's Law for determining the coil's rotation direction. Clarification on the equations and their application is requested, indicating a lack of prior instruction on these concepts.
bpaterni
Messages
8
Reaction score
0

Homework Statement



1.A circular coil, with radius of 10 cm, and 25 turns, rotates in a constant magnetic field of
strength 2.4 T, with the axis of rotation perpendicular to the direction of the magnetic
field.

A. If the coil rotates at a frequency of 50 Hz, what is the induced peak voltage?
B. Sketch the time-dependence of the induced voltage.
C. If the magnetic field that the coil is in points down the page, which direction does the coil rotate? Answer for both cases: (1) q traveling from left to right and (2) q traveling from right to left in the coil.

Homework Equations



V = -N * [ dΦ / dT ]
Φ = B * A * cosθ

V = -N * B * A * ω*sinθ
ω = 2π*f

The Attempt at a Solution



A. A = π*.1^2
.031416 m^2

ω = 2π*50
314.159 rad/s

peak voltage would occur when the coil is perpendicular to the magnetic field correct? So would I put π/2 in for sin(x) and get the following?
V = 25 * 2.4 * .031416 * 314.159*sin(π/2)
1.88496 * 314.159
592.177 V
B. If A is correct, then would the time-dependence of induced emf look like a sin wave?
C. I take it I'm supposed to use the right-hand-rule and Lenz's Law for this question, but I'm slightly confused as to how to go about doing so
 
Last edited:
Physics news on Phys.org
bump, I believe A and B are correct from what I understand, but I'm still having trouble with C.
 
I need help with this question too.
 
Yeah, I don't understand how to use the 50Hz to determine the peak voltage. I really hate this class! None of this was taught in the lesson or explained at any point. An explanation of the equations would be helpful. Please, anyone?
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top