Can I Charge Capacitors Without a Step-Up Transformer?

  • Thread starter Thread starter alpine2beach
  • Start date Start date
  • Tags Tags
    Capacitors Charge
AI Thread Summary
Charging a capacitor requires a voltage source equal to or greater than the desired capacitor voltage. To achieve higher DC voltage from a lower DC source without a step-up transformer, voltage doubler circuits and charge pumps can be utilized. Charge pumps work by charging capacitors in parallel and discharging them in series, effectively increasing the voltage. These methods are particularly useful for applications like battery-powered devices. Understanding these concepts can help in designing circuits that meet specific voltage requirements.
alpine2beach
Messages
25
Reaction score
1
I know that in order to charge a capacitor, you must have a power source voltage greater than or equal to the desired voltage in the capacitor. Knowing this, is there any way to achieve a higher voltage DC(from a lower voltage DC) without using a step-up transformer?
 
Engineering news on Phys.org
Look up charge pumps.
 
triden said:
You might want to take a look at voltage doubler circuits. These are used in PC power supplies to convert 110 VAC to the 220 VAC that the supplies run on.

http://en.wikipedia.org/wiki/Voltage_multiplier

I need to use batteries, so AC is out of the question.
 
Studiot said:
Look up charge pumps.

Thanks. That's pretty much what I need. Now all I have to do is figure out wiki... So basically a charge pump is a device that charges capacitors in parallel and discharges in a series?
 
alpine2beach said:
Thanks. That's pretty much what I need. Now all I have to do is figure out wiki... So basically a charge pump is a device that charges capacitors in parallel and discharges in a series?

Right.
 
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...

Similar threads

Back
Top