How to Connect a Signal Generator to Multiple Components?

  • Thread starter Thread starter taleebe
  • Start date Start date
  • Tags Tags
    Generator Signal
AI Thread Summary
To connect a signal generator to multiple components, a common approach is to use a T-junction or a splitter cable from the signal generator's output. This allows for simultaneous connections to both the capacitor and the resistor while maintaining signal integrity. It's important to ensure that the connections do not overload the signal generator. Merging similar threads can help consolidate information and avoid redundancy. The discussion emphasizes the need for clarity in setup to achieve effective results.
taleebe
Messages
11
Reaction score
0
I'm trying to connect a signal generator as in the following configuration, my signal generator has an output port that i can connect to the capacitor in the diagram on a prorotype breadboard but what about the connection to the 3R3 resistor and DC supply? is there a special wire that goes from the signal generator output, splits into two that i can connect? or perhaps some kind of T-junction at the output port of the signal generator?
 

Attachments

  • pop-pop.JPG
    pop-pop.JPG
    25.6 KB · Views: 427
Engineering news on Phys.org
This is very similar to your other thread here with the same circuit, taleebe. Do you want me to merge the two threads? Or are you asking something significantly different here?
 
A merge would be ideal,thank you
 
I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
Thread 'How Does Jaguar's 1980s V12 Dual Coil Ignition System Enhance Spark Strength?'
I have come across a dual coil ignition system as used by Jaguar on their V12 in the 1980's. It uses two ignition coils with their primary windings wired in parallel. The primary coil has its secondary winding wired to the distributor and then to the spark plugs as is standard practice. However, the auxiliary coil has it secondary winding output sealed off. The purpose of the system was to provide a stronger spark to the plugs, always a difficult task with the very short dwell time of a...
Back
Top