How to convert cm^-1 into erg or joules

  • Thread starter Thread starter AutisticAlien
  • Start date Start date
  • Tags Tags
    Convert Joules
AI Thread Summary
The discussion addresses the conversion of cm^-1 into energy units like erg or joules, clarifying that cm^-1 is not a direct unit of energy. It explains that cm^-1 can relate to the energy of photons, specifically referencing a photon with a wavelength of 1 cm, which equates to approximately 1.99 x 10^(-23) joules. The conversation also highlights the importance of context, as the original inquiry stemmed from a chemistry problem involving crystal fields. Ultimately, the participants confirm that while cm^-1 cannot be converted directly to energy, it can be associated with photon energy calculations. Understanding these relationships is crucial for solving related chemistry problems.
AutisticAlien
Messages
9
Reaction score
0
I'm not sure if this is the right place for this, but I can't seem to find how to convert cm^-1 into erg or joules... It's a pretty dumb question, but I can't find the answer anywhere.

Thanks a lot in advance!
 
Physics news on Phys.org


You cant, because cm^(-1) is not a unit of energy. The base units of energy are m l t^(-2). For example Ergs are grams cm seconds^(-2) and Joules are kg m seconds^(-2).
 


The only meaning that I can think of for that is perhaps comparing the energy to that of a photon of wavelength one cm.

For example, a photon of wavelength 1mm would have an energy of 10 cm^(-1) and so on.

In that case the conversion factor would just be the energy of a photon wavelength 1cm, which is 100 h c, or about 1.99 x 10^(-23) Joules.

In what context did you see this unit used Alien?
 


Failed to mention context, sorry. But yes, it was the way you predicted. Thank you very much!

It was a Chemistry problem about crystal fields.
 
Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Back
Top