How to test CST design studio for analyzing data errors

Click For Summary
To test the effect of EMI on data passing through cables in CST Design Studio, it's essential to specify the electrical data parameters accurately. The discussion suggests simulating tests in line with EN 61000-4-3 and EN 61000-4-6 standards for RF noise immunity. Users are encouraged to share their system specifications, including details about the transmitter, receiver, and cabling. Additionally, a recommended e-seminar on the CST website provides further insights into aerospace EMC simulation. Proper setup and simulation can help analyze potential data errors effectively.
Nikhil N
Messages
80
Reaction score
2
Hi..
I want to know how can we specify the data(electrical) passing through cable that we are designing in CST design studio to test the effect of EMI on the data passing?
 
Engineering news on Phys.org
Are you basically wanting to simulate testing that you might do per EN 61000-4-3 (radiated) and EN 61000-4-6 (conducted) RF noise immunity testing? Can you post a copy of the system you want to simulate, including specifications on your transmitter, receiver and cabling?

Also, have a look at this e-seminar at the CST website (under the "Solutions" section):

https://www.cst.com/solutions/article/aerospace-emc-simulation
 
Thread 'I thought it was only Amazon that sold unsafe junk'

Thread 'I thought it was only Amazon that sold unsafe junk'

I grabbed an under cabinet LED light today at a big box store. Nothing special. 18 inches in length and made to plug several lights together. Here is a pic of the power cord: The drawing on the box led me to believe that it would accept a standard IEC cord which surprised me. But it's a variation of it. I didn't try it, but I would assume you could plug a standard IEC cord into this and have a double male cord AKA suicide cord. And to boot, it's likely going to reverse the hot and...
View full post »

Similar threads

DC-voltage sweep @CST Design Studio
  • · Replies 2 ·
Replies
2
Views
2K
Recommendation Needed for a Spectrum Analyzer
  • · Replies 46 ·
2
Replies
46
Views
4K
EMI(Electro Magnetic Interference) Magnitude and Frequency
  • · Replies 5 ·
Replies
5
Views
2K
How to automate tests on a physical model without real data
  • · Replies 4 ·
Replies
4
Views
1K
Meaning of flush error received from mod-bus slave
  • · Replies 8 ·
Replies
8
Views
4K
Op-amp compensation of cascade fudges audio signal oddly
  • · Replies 3 ·
Replies
3
Views
2K
How Can I Shield My Circuit from EMI Caused by a High-Voltage Pulse Transformer?
  • · Replies 1 ·
Replies
1
Views
2K
How can I effectively suppress Poisson noise in my data?
  • · Replies 19 ·
Replies
19
Views
2K
Design of CT with ferrite core for reverse operation of CT
  • · Replies 3 ·
Replies
3
Views
2K
Project: Speed and force control of a linear actuator
  • · Replies 7 ·
Replies
7
Views
4K