I need to find the length, weight of the bob and angle to make the

AI Thread Summary
To achieve a complete revolution of a pendulum, it must be released from a vertical position, pointing straight up. The length and weight of the bob do not affect this requirement, as the motion is governed by conservation of energy. Neglecting friction is crucial, as any resistance would prevent a full revolution. The initial release angle is the key factor in achieving the desired motion. Therefore, starting the pendulum at the correct angle is essential for a complete revolution.
ambalam
Messages
2
Reaction score
0
I need to find the length, weight of the bob and angle to make the pendulum a complete revolution. Kindly help me.
 
Physics news on Phys.org


Neglecting friction, a pendulum only swings as high as you initially release it from due to conservation of energy. So if you want a complete revolution, you will have to start the pendulum pointing straight up and get rid of the friction. It does not depend on length or weight.
 


thanks dude.
 
Thread 'Is 'Velocity of Transport' a Recognized Term in English Mechanics Literature?'

Thread 'Is 'Velocity of Transport' a Recognized Term in English Mechanics Literature?'

Here are two fragments from Banach's monograph in Mechanics I have never seen the term <<velocity of transport>> in English texts. Actually I have never seen this term being named somehow in English. This term has a name in Russian books. I looked through the original Banach's text in Polish and there is a Polish name for this term. It is a little bit surprising that the Polish name differs from the Russian one and also differs from this English translation. My question is: Is there...
View full post »
Thread 'Beam on an inclined plane'

Thread 'Beam on an inclined plane'

Hello! I have a question regarding a beam on an inclined plane. I was considering a beam resting on two supports attached to an inclined plane. I was almost sure that the lower support must be more loaded. My imagination about this problem is shown in the picture below. Here is how I wrote the condition of equilibrium forces: $$ \begin{cases} F_{g\parallel}=F_{t1}+F_{t2}, \\ F_{g\perp}=F_{r1}+F_{r2} \end{cases}. $$ On the other hand...
View full post »

Similar threads

I Will This Friction Clamp Hold the Weight?
Replies
10
Views
2K
I Solving for the Motion of a Spring Pendulum
2
Replies
76
Views
7K
A Modeling the damping of a physical rigid pendulum
Replies
1
Views
2K
The period of oscillation of a bob in an accelerating frame
Replies
5
Views
1K
I Moment of inertia of human body with limbs at an angle
Replies
12
Views
2K
B Can I hold down more than my body weight on a 1 to 1 system?
Replies
13
Views
3K
I Understanding tension and centripedal force in a puck and weight
Replies
4
Views
2K
B How Does Inclined Load Affect Weight Distribution When Moving a Cabinet?
Replies
1
Views
1K
The Force Of The Ladder Against The Wall
Replies
2
Views
2K
Max. acceleration of a pendulum changes with its length and mass?
Replies
1
Views
3K

Hot Threads

Recent Insights

Back
Top