Is There a New, More Efficient Electric Motor?

AI Thread Summary
A new electric motor claims to offer improved efficiency, raising questions about its adherence to the laws of thermodynamics. Participants are seeking information on real-world testing and performance of this motor. Previous discussions on increasing motor efficiency have been referenced for context. The conversation emphasizes the need for empirical evidence to support claims of enhanced efficiency. Further contributions should be directed to the original thread for continuity.
Fisherman199
Messages
46
Reaction score
35
TL;DR Summary
Robert Downey Jr., Bill Gates, et al have backed a startup to produce more efficient electric motor
Electric Motor Start-Up

I have done little research into this so far but my "Law of Thermodynamics" alarm is blaring loud-and-clear. Has anyone here heard of this "new motor?" Has anyone tested one in the field?
 
Engineering news on Phys.org
Any further posts should be in that original thread. Thanks.
 
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
Back
Top