Is Velocity Conserved in a Falling Balls Collision Experiment?

  • Thread starter Thread starter rahmatkat
  • Start date Start date
  • Tags Tags
    Balls Falling
AI Thread Summary
In the discussed experiment, two balls are involved in a collision where one is released from a ramp and strikes a stationary ball. The key question is whether velocity and momentum are conserved during this collision. To determine this, calculations must be made for initial and final momentum (P_i and P_f) and kinetic energy (E_{k_i} and E_{k_f}). It is essential to consider that the kinetic energy of the moving ball before the collision equals its initial potential energy, while also accounting for rolling motion as a form of kinetic energy. Understanding these principles is crucial for accurately analyzing the conservation of momentum and energy in the experiment.
rahmatkat
Messages
15
Reaction score
0
Hi there, can anyone help me with this problem, I'll be grateful to received your help.

It was like this, we were doing an experiment on collision and this is how it goes;

We place a ramp on table and a sheet of paper at the bottom of the table but close to the edge. Then we put two balls, one at the top of the ramp ready tobe release and one at the end of the ramp (stationary).Then the ball at the top of the ramp was release and hit the ball at the bottom, the diagram which I have drawn shows the direction of the two balls and a resultant.:smile:

View attachment Collision.doc


The Question is that, we have to explain if a velocity for this experiment is conserved or not and if momentum of collision is also conserved or not?
 
Last edited:
Physics news on Phys.org


I don't quite know how the rest of the experiment goes, but from what I can see, you're supposed to determine whether momentum is conserved, and whether mechanical energy is conserved (What the instructions called velocity).

Look to see if the following two conditions hold true, by calculating the left and ride side of each equation:
P_i=P_f
E_{k_i}=E_{k_f}

Remember that the kinetic energy of the impacting ball right before the collision is equal to its initial potential energy (Assuming conservation of energy, you'd have to neglect the effect of friction to achieve this).

Oh, and don't forget that rolling motion is another form of kinetic energy, so you'd have to take that into account as well.
 


So I have to find out the kinectic energy of the two ball's as well, I think that were i got everything wrong 'cause I was only trying to find the velocity of the balls. Thank for the help.
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Trying to understand the logic behind adding vectors with an angle between them'
My initial calculation was to subtract V1 from V2 to show that from the perspective of the second aircraft the first one is -300km/h. So i checked with ChatGPT and it said I cant just subtract them because I have an angle between them. So I dont understand the reasoning of it. Like why should a velocity be dependent on an angle? I was thinking about how it would look like if the planes where parallel to each other, and then how it look like if one is turning away and I dont see it. Since...
Back
Top