ME Interview for Writing Class Needed

AI Thread Summary
A mechanical engineering student at the Oregon Institute of Technology seeks to interview a mechanical engineer for a writing class, focusing on communication methods like proposals and recommendation reports. The request for assistance is made publicly, but privacy concerns have led to a general exclusion of interviews on the forum. Participants may choose to reach out via private message instead of responding in the open thread. The student expresses appreciation for any help offered. Engaging in this project could provide valuable insights into professional communication in engineering.
JW2010
Messages
1
Reaction score
0
I am a mechanical engineering student at the Oregon Institute of Technology and am looking to interview a mechanical engineer for a writing class. I am interested in learning what types of communication you use such as proposals and recommendation reports. If anyone would be willing to help with this project I would appreciate it. Thanks
 
Engineering news on Phys.org
Welcome to PF, JW2010.
Interviews have pretty much been excluded from PF due to privacy issues. Someone might choose to contact you by PM, but not in an open thread.
 

Thread 'Race car suspension Class'

Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
View full post »

Thread 'Cantilever help'

I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
View full post »
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'

Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'

Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
View full post »

Similar threads

Mechanical Engineer Career. Short 3 question interview.
Replies
1
Views
1K
Need to interview a Mechanical Engineer
Replies
1
Views
2K
Can You Help Find a Mechanical Engineer for an Urgent Student Interview?
Replies
1
Views
1K
Help Needed: Experienced Mechanical Engineer for Interview
Replies
2
Views
1K
Professional Mechanical Engineer Interview
Replies
1
Views
2K
Mechanical Engineer Needed for Interview Please
Replies
3
Views
1K
I need to interview an engineer for a school project.
Replies
1
Views
2K
Admissions Applying for Physics PhD in the UK 10 years after leaving Uni
Replies
2
Views
2K
Engineer Needed: Interview for Engineering Class (10 Questions)
Replies
1
Views
2K
I need to interview an electrical engineer (School related)
Replies
1
Views
3K

Hot Threads

Recent Insights

Back
Top