Measuring Thermal Conductivity of a Wall: Simulating & Measuring Heat Flow

AI Thread Summary
To measure the thermal conductivity of a wall, the formula K=Q*d/A(t2-t1) is used, where K is conductivity, d is thickness, A is area, and Q is heat flow. The main challenge is simulating heat in the experiment and accurately measuring the heat flow. One suggested approach is to heat a material with known conductivity to minimize heat loss during testing. Effective experimental design and insulation can help achieve more accurate results. Creative thinking and consideration of surrounding factors are also encouraged in the experimental process.
motaz
Messages
2
Reaction score
0
HI
I would like to test the thermal conductivity of r wall by

K=Q*d/ A (t2-t1)

K =conductivity
d+=thickness
A= area

Q= heat flow

my problem how I could simulate heat in my experiment and how I will measure the heat flow?

could you please help me.
Kind regards
 
Engineering news on Phys.org
By heating the material which you know its heat conductivity if you can provide good experience by close the transmission heat loss to zero.

--------------------------------
Creative thinking is breezy, Then think about your surrounding things and other thought products. http://electrical-riddles.com
 
m.s.j thank you for your answer.
 
Thread 'Weird near-field phenomenon I get in my EM simulation'

Thread 'Weird near-field phenomenon I get in my EM simulation'

I recently made a basic simulation of wire antennas and I am not sure if the near field in my simulation is modeled correctly. One of the things that worry me is the fact that sometimes I see in my simulation "movements" in the near field that seems to be faster than the speed of wave propagation I defined (the speed of light in the simulation). Specifically I see "nodes" of low amplitude in the E field that are quickly "emitted" from the antenna and then slow down as they approach the far...
View full post »

Thread 'EMF (Electromagnetic Field) & EHS (Electromagnetic Hyper Sensitivity)'

Hello dear reader, a brief introduction: Some 4 years ago someone started developing health related issues, apparently due to exposure to RF & ELF related frequencies and/or fields (Magnetic). This is currently becoming known as EHS. (Electromagnetic hypersensitivity is a claimed sensitivity to electromagnetic fields, to which adverse symptoms are attributed.) She experiences a deep burning sensation throughout her entire body, leaving her in pain and exhausted after a pulse has occurred...
View full post »

Similar threads

Solenoid valve thermal part
Replies
24
Views
2K
Thermal Resistance between Chip to Gold Tin Solder
Replies
5
Views
2K
I How to measure average thermal conductivity of a metallic material?
Replies
1
Views
2K
Thermal conductance of an angular section of a disc
Replies
4
Views
2K
I Generate heat conduction curves at different time steps
Replies
7
Views
2K
How does a digital multimeter measure conductance?
Replies
14
Views
5K
Coefficient of Thermal conductivity
Replies
4
Views
2K
Heat transfer Rate
Replies
2
Views
2K
I Warm-up time for a hollow cylinder
Replies
5
Views
2K
Errors in Experiment with Low and High Conductivity Materials
Replies
2
Views
1K

Hot Threads

Recent Insights

Back
Top