Unraveling the Mysteries of USB Power Supply: Is it Just 5V or Something More?

AI Thread Summary
USB power supply typically delivers 5V, but the actual power output is measured in watts, with standard USB ports providing around 2.5W (500mA at 5V). The voltage is regulated, and if the device attempts to draw more than the available current, the voltage may drop. The power input to the USB is transformed from higher voltages (like 110V or 240V) down to a lower voltage, often around 18V for laptops, before being converted to 5V for USB output. This process involves a transformer and a regulator to ensure the correct voltage is supplied. Understanding these components clarifies how USB power systems function.
OnceMore
Messages
23
Reaction score
1
Hello.

This is probably a silly question. But it is something I haven't been able to find an answer too.

When I connect something to my laptop through the USB, I know that there is 5V coming from the USB connection ...there are many pinout diagrams about that show this. But what is the power into the USB. Surely it is not just 5V's.

Is there some sort of linear/switching regulator at work here?

Like I said, sorry of this is a silly question, I have just being wondering, and I haven't been able to find a decent answer.

Thanks.

-S
 
Engineering news on Phys.org
OnceMore said:
...

But what is the power into the USB. Surely it is not just 5V's.

...

-S

Sorry but this does not make much sense. Power is expressed in Watts not Volts. So it is nonsense to ask if the power is 5V. That is sort of like asking "what time is it ? and getting an answer of 5lbs"

The usual spec for a computer USB port is 500ma @ 5V so the power available is 2.5W. The voltage is pretty well regulated and will not vary much unless you try to pull more then the 1/2 amp available. Then it may drop, and, likely, will be followed by smoke.
 
Ah sorry. I meant voltage into the USB. I obviously didn't pay too much attention to what I was writing. Sorry.

So, I take it there is a regulator on the input to the USB, which will take it down to the required spec?

-S
 
Correct, but bear in mind that it isn't going from 240V (or 110V) to 5V. There's a main transformer which takes it down from 240V on the way in and outputs it to a standard (I think it's 18V for my laptop) and then it is taken from there to 5V.
 
Last edited:
That's great, thanks!

I figured it was something along those lines, but I was 100%.

Many thanks.

-S
 
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
Back
Top