Need help finding high voltage transformer

AI Thread Summary
A user is seeking a high voltage transformer similar to a modified x-ray transformer but has been unable to locate one. They request assistance in finding this specific type of transformer. Additionally, they inquire about purchasing a case for the transformer, which is identified as a "shielded enclosure" designed to contain electromagnetic radiation. Another user responds, clarifying the purpose of the case but does not provide information on the transformer itself. The discussion highlights the challenges in sourcing specialized electrical components and protective enclosures.
JerryG
Messages
58
Reaction score
0
I am trying to find a high voltage transformer with the configuration shown below. The guy that took the picture says that it is an x-ray transformer that he modified slightly, but after all my searching, I can't find a transformer like it. Has anyone seen this type of transformer or know where to get it?

Also, does anyone know where to buy a case like the one the transformer is sitting inside of?

transformer.jpg
 
Engineering news on Phys.org
JerryG,

Sorry, I have no information on the HV transformer. But the case is a "shielded enclosure" made to contain all electromagnetic radiation (RF) so as not to interfere with external electronics.
 

Thread '3-terminal device external modeling'

Very basic question. Consider a 3-terminal device with terminals say A,B,C. Kirchhoff Current Law (KCL) and Kirchhoff Voltage Law (KVL) establish two relationships between the 3 currents entering the terminals and the 3 terminal's voltage pairs respectively. So we have 2 equations in 6 unknowns. To proceed further we need two more (independent) equations in order to solve the circuit the 3-terminal device is connected to (basically one treats such a device as an unbalanced two-port...
View full post »

Thread 'Question about the voltage between two charged capacitors'

suppose you have two capacitors with a 0.1 Farad value and 12 VDC rating. label these as A and B. label the terminals of each as 1 and 2. you also have a voltmeter with a 40 volt linear range for DC. you also have a 9 volt DC power supply fed by mains. you charge each capacitor to 9 volts with terminal 1 being - (negative) and terminal 2 being + (positive). you connect the voltmeter to terminal A2 and to terminal B1. does it read any voltage? can - of one capacitor discharge + of the...
View full post »

Similar threads

Why does the high voltage side of transformers tend to burn out first?
Replies
37
Views
9K
Low Voltage to Low Voltage Transformer for <1A Output Current
Replies
20
Views
4K
Design of a CW multiplier circuit
Replies
22
Views
4K
Is My Thyristor Gate Driver Circuit Malfunctioning Due to Component Issues?
Replies
12
Views
2K
What is the Wavelength of Corona Discharge in High Voltage Testing?
Replies
7
Views
2K
Transformer N1V1=N2V2 works only one freq
Replies
6
Views
4K
"Ground" and "Center Tapped" Power Transformer Secondary in guitar amp
Replies
6
Views
3K
What's the normal low-load working temperature for an SMPS transformer?
Replies
27
Views
5K
Current through Flat Sheet or plate
Replies
14
Views
3K
High-energy LC oscillatory discharge: what kind of switch?
Replies
19
Views
1K

Hot Threads

Recent Insights

Back
Top