Planar Kinematics of a Rigid Body

AI Thread Summary
The discussion revolves around a student seeking help with planar kinematics problems in preparation for an upcoming test. They express a desire to ensure they understand the material correctly to perform well. Participants encourage sharing solutions to the problems for better understanding. The focus is on collaborative learning and preparation strategies for the test. Engaging with peers for assistance is highlighted as a beneficial approach to mastering the subject.
Gnat85
Messages
1
Reaction score
0
I have been given the following problems for practice for an upcoming test that is going to have similar problems on it. I was wondering if someone knows how to do them as I want to make sure that I know how to do them correctly so I will be prepared come test time. Thank you!
 

Attachments

Physics news on Phys.org
Gnat85 said:
as I want to make sure that I know how to do them correctly so I will be prepared come test time.

So, show us how you do them! :wink:
 
Thread 'Minimum mass of a block'

Thread 'Minimum mass of a block'

Here we know that if block B is going to move up or just be at the verge of moving up ##Mg \sin \theta ## will act downwards and maximum static friction will act downwards ## \mu Mg \cos \theta ## Now what im confused by is how will we know " how quickly" block B reaches its maximum static friction value without any numbers, the suggested solution says that when block A is at its maximum extension, then block B will start to move up but with a certain set of values couldn't block A reach...
View full post »

Thread 'Electric field due to charges between 2 parallel infinite planes'

TL;DR Summary: Find Electric field due to charges between 2 parallel infinite planes using Gauss law at any point Here's the diagram. We have a uniform p (rho) density of charges between 2 infinite planes in the cartesian coordinates system. I used a cube of thickness a that spans from z=-a/2 to z=a/2 as a Gaussian surface, each side of the cube has area A. I know that the field depends only on z since there is translational invariance in x and y directions because the planes are...
View full post »
Thread 'Calculation of Tensile Forces in Piston-Type Water-Lifting Devices at Elevated Locations'

Thread 'Calculation of Tensile Forces in Piston-Type Water-Lifting Devices at Elevated Locations'

Figure 1 Overall Structure Diagram Figure 2: Top view of the piston when it is cylindrical A circular opening is created at a height of 5 meters above the water surface. Inside this opening is a sleeve-type piston with a cross-sectional area of 1 square meter. The piston is pulled to the right at a constant speed. The pulling force is（Figure 2）： F = ρshg = 1000 × 1 × 5 × 10 = 50,000 N. Figure 3: Modifying the structure to incorporate a fixed internal piston When I modify the piston...
View full post »

Similar threads

Problem in understanding angular momentum of a rigid body
Replies
10
Views
2K
I Frame Transformation in rigid bodies
Replies
4
Views
1K
What does it mean that a rigid body is in equilibrium?
Replies
3
Views
2K
Where on a rigid body is a resultant force applied?
Replies
11
Views
1K
Conservation of Linear Momentum of Rigid Body
Replies
3
Views
1K
Rigid body rotation problem: Mass on a cord spinning up a wheel on an axle
Replies
15
Views
2K
Rigid body dynamics: A rod with two masses rotates down from a horizontal starting position
Replies
21
Views
1K
Is it friction or tension acting on the person hanging on a rope?
Replies
4
Views
1K
The Effect of Increasing the Size of a Solid on Its Entropy
Replies
1
Views
1K
A Rigid body motion (RBM) transformation
Replies
3
Views
1K

Hot Threads

Recent Insights

Back
Top