Relation between irrotational and inviscid

  • Thread starter Thread starter haisol
  • Start date Start date
  • Tags Tags
    Relation
AI Thread Summary
Irrotational and inviscid fluids are related but distinct concepts in fluid dynamics. A fluid is classified as irrotational if the curl of its velocity field is zero, indicating no vorticity. An inviscid fluid, on the other hand, cannot generate vorticity, meaning that an initially irrotational fluid will remain so. However, a fluid can still exhibit rotational characteristics under certain conditions, such as shockwaves, even if it is inviscid. Understanding the nuances between these terms is crucial for accurately describing fluid behavior in various scenarios.
haisol
Messages
5
Reaction score
0
I want to know the relation between irrotational and inviscid.
Is it irrotational if the fluid is inviscid? Or inviscid if it's irrotational?

That's because my professor always write these two together as a constraint.
And he sometimes says that it can be rotational even if it's inviscid, for the case of shockwave.
Then is it always inviscid if it's irrotational? I'm so confused.
 
Engineering news on Phys.org
The two terms are not one in the same. A fluid is irrotational if the curl of the velocity field is identically zero everywhere - it has no vorticity. For an inviscid fluid, vorticity cannot be generated, so a fluid that begins irrotational will remain irrotational indefinitely. For a viscous fluid, the effect of viscosity allows an otherwise irrotational fluid to generate some vorticity on its own such as in a shear layer or von-Karman shedding behind a cylinder.
 
thank you very much!
 
Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'
Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
Back
Top